World Dryer ABC-300H Instrucciones Para La Instalación página 3

•
A stud MUST be located and used for at least one side of the diaper changing station.
•
The diaper changing station is no stronger than the anchors or walls to which they are attached and, therefore, MUST be
firmly secured in order to support the weight they are intended to support. Contact an architect or building contractor
if any questions.
1. Locate wood stud where left side of changing station will be mounted to the wall.
2. Measure up 42" (107 cm) from the floor and mark the wall. This locates the position
for the top left attachment hole.
NOTE: Mark on wall MUST be in center of wood stud.
3. Align hole in top left corner of changing station with mark on wall and hold in place.
4. Using a level and measuring tape, mark the remaining three (3) holes. After marking holes,
set changing station down on ground.
5. Use a power drill and appropriate bit to drill four (4) holes in the wall. This may require
2 people.
NOTE 1: For wood studs:
- If finished wall surface is tile or masonry over wood studs, use
a 7/32" masonry bit for the pilot hole until you hit the wood
stud, then change to 1/8" bit.
- Use wood screws, finishing washers and flat washers (Fig. a).
NOTE 2: For use with toggle anchors:
- If finished wall surface has wood studs that are not 16" on center,
has metal studs, or has an underlying surface of concrete block,
use 1/2" bit.
- Use machine screws and flat washers (Fig. b).
- For holes NOT located in a wood stud, toggle anchors MUST be
used (Fig. c). See "Using Toggle Anchors" section.
6. Align holes in changing station with drilled holes and secure top left corner of changing
station to wall stud using the appropriate screw and washer. Continue to secure the
three (3) remaining corners using the appropriate screws and washers as described
in Note 1 or Note 2.
•
All 4 of these locations MUST be used for safe installation. The lower holes ensure
installation through the metal brackets.
7. Ensure all four (4) screws are tight and snap caps over screw heads.
Using Toggle Anchors:
1. Insert metal end of toggle anchor into 1/2" hole.
2. Slide zip strip down snugly against wall.
3. Snap off break-away pieces of toggle anchor (Fig. d).
4. Align holes in changing station with toggle anchors and secure top left corner of changing station to
wall using machine screws and flat washers. Continue to secure the three (3) remaining corners
using machine screws and flat washers.
5. Ensure all four (4) screws are tight and snap caps over screw heads.
WARNING
INSTALLATION
WARNING
2
Flat
Wood Stud
Washer
Finishing
Washer
Wood
Screw
Fig. a
Changing
Station
Toggle
Anchor
Wood Stud
Changing
Station
Machine
Screw
Fig. b
Fig. c
Toggle
Wood Stud
Anchor
Break-Away
Fig. d
Flat
Washer