Tabla de contenido
Publicidad
OPERATING INSTRUCTIONS
Cord Assembly
1. The interconnecting cord emerges
from the rear left side of the power
nozzle and connects to the handle
underneath the power cord quick
release holder. Press the
interconnecting cord into the cord
clamp above the steering lock.
(Fig. 7)
Interconnecting
Cord Clamp
Interconnecting
Cord
Fig. 7
2. Press the interconnecting cord
into the cord clamp located on the
inside of the carrying handle.
(Fig. 8)
Interconnecting
Cord Clamp
Fig. 8
3. Make sure that the quick release
power cord holder is in the upright
position.
4. Remove the wire tie from the power
cord
5. Wrap the cord into place by winding it
around the power cord quick release
holder and the lower cord holder.
(Fig. 9 and 10)
Quick
Release Power
Cord Holder
Fig. 9
Lower Cord
Holder
Fig. 10
6. To unwrap the cord, turn the quick
release cord holder to the left or right.
WARNING:
Do not plug in if the power
switch is in the "I" or "II" position.
CAUTION
: Make sure a disposable
HEPA dust bag is in place before
operating. DO NOT operate the vacuum
cleaner without a HEPA dust bag.
7. Plug the power cord into an electrical
outlet and press the On/Off/Turbo
power switch when ready to operate.
NOTE
: Your vacuum will not turn on
when the handle is in the upright and
locked position. Press the handle release
and then turn on your vacuum using the
power switch.
WARNING:
Avoid leaving the vacuum in
one place for an extended period of time,
particularly on thick carpet.
The Off/On/Turbo Fingertip Power
Switch
The fingertip power switch has two
speed settings. Position "I" should be
used on area rugs, bare floors and
carpets. Position "II" is a higher power
and is intended for deeper carpet
cleaning on full sized carpets.
Off/On/Turbo
Fingertip
Power Control
Fig. 11
= OFF
ON
= (Bare Floors,
Area Rugs,
Carpets)
Turbo
Fig. 12
=
(Carpets)
1.
Push the power switch down. The
power switch will click into the "I"
position. This turns the vacuum
on.
2.
Push the power switch from
position "I" to position "II" for turbo
power.
3.
Push the power switch up into the
"O" position to turn the vacuum off.
5
INSTRUCTIONS D'UTILISATION
7.
Enlevez le bulbe de lumière en tirant
fermement mais délicatement sur la
douille.
8.
Replacez le nouveau bulbe en le
poussant fermement à l'intérieur de
la douille.
9.
Replacez le couvercle de plastique
sur la buse d'aspiration et retournez
l'aspirateur sur le côté afin d'avoir
accès à la plaque inférieure.
10. Resserrez soigneusement les vis en
utilisant un tournevis. NE serrez
PAS trop.
Entreposer Votre Aspirateur Balais
1. Lorsque vous avez terminé de passer
l'aspirateur, mettez votre appareil en
position d'arrêt en déplaçant
l'interrupteur.
2. Appuyez sur la poignée de
l'aspirateur pour la remettre en
position verticale et verrouillée.
3. Enroulez le cordon d'alimentation
autour de supports de dégagement
rapide et de la poignée de transport.
4. Attachez la pince en « U » du cordon
d'alimentation sur le cordon enroulé.
34
Publicidad
Tabla de contenido
