Publicidad
Idiomas disponibles
Idiomas disponibles
iii!FiiiiiiiiiiiiiiiFii iiF iiiiiiii
iiiiiii!iiiiiFFiiiiiiiiii!iiiiiiiii i
i i
Review
this table to find do-it-yourself
solutions
for minor performance
problems.
Any ser-
vice needed,
other than those described
in this owner's
manual,
should
be performed
by
an authorized
Sears Service
Center.
WARNING
Electrical
Shock
Hazard
Disconnect
electrical
supply
before
servicing
or cleaning
the unit.
Failure
to do so could result
in electrical
shock or personal
injury.
I
Cleanerwon't start.
Poorjob of dirt
pick-up,
Cleaner starts but
cutsoff.
1, Unplugged at wail ougeL
2. Tripped circuit txeakedbinwn fuse
at hoL;sehold service panel.
3. Loose hose electrical connections.
1. Full or clogged dust bag.
2. Clogged airflow passages.
3. Dirty filters.
4.
Wrong pile height setting
5. Suction control is open.
6, Hole in hose.
7, Worn Power-Mate _" agitator.
8, Worn or b_oken belt.
9,
Dirty agitator or end caps.
10.
Canister hcod open.
1. Hose o_ hond electrical connections.
2. Tripped ovedcad protector in
P_wer.Mate s.
3. Tripped thermal pzetectof
in canister.
1. Plug in firmly, pushON/OFFswitch_ ON.
2. Reset circuilbreakeror replace fuse.
3, Reconnect hose ends, (page 7)
1. Change bag, (page t3).
2. Clear ai_ow passages, (page 13)`
3. Change lifters, (page 14-15).
4. Adjust setting, (page 10).
5. Adjust control (page 11).
6. Replace hose.
7. Change agffator. (page 18)
$&tt.
See BELT CHANGING AND AGITATOR
CLEANING
(pages 16-17).
10. Clese and latch hood.
1.
2.
3.
Ched_ mnnec_s, _or=',ect hose eeds, ( page7),
Removeany itemsthat maybe caagh_
orjammed,then reseL If cleaner starts
andstopsagain,clean agitator andendcaps,
thenreset,(pages11.16-17).
Turnoffand unplug thevacuum fr_, oulleland
waitapproximately 5 0 minutesandplugthe vacu-
umin, lureback on to see if the protector has
reset,(page 12) Changedustbag,clear airflow
blockage,(page 13).
POWER-MATE _ will not
1. Power-Male _ connectlens
1. Plug_nfirmly,(page6).
run when attached,
unplugged¸
2. Wornor b_oken belt.
2 & 3. See BELTCHANGINGAND AGITATOR
3, Dirtyagitate(orend caps+
CLEANIN_ (pages16-17)
4. Tr;pgedovedoadpmtectcrin
4. Checkagitaler areaforexcessivellnt
Pew---Mate_
build-up or jamming. C leanag_tor and
end caps, thenreset, (pages 11, 16-17).
5. Switchnot in CARPETposition.
5. Move switch to CARPETpasition. (page 8).
Electronic8agtHose
1. Fullor cloggeddustbag,
1. Changebag,(page13),
Check Indicatoractivates.
2, Ditty riflers.
2. ChangeI_llers, ( page 14-15).
3. Bledxedairflow passage.
3. Clearblect<age f romairflow passage.(page13).
4. Certainattar, hmentloots,
4. Thisis non'nat. Light shouldgooff
whentoo]is removed.
Cleaner picks up moveable
1. Wrongpileheightsetting.
1. AdjList s etting, ( page 10).
rUgS"or-POWER..MATE _
2. Sl_ctiontooatrong
2. Oge_suctinncontr_.(page 11),
_ushastoo hard.
Ught won't work.
1. Burned out lightbulb.
1. Cba_gelightbulb,(page17).
Cord won't rewind.
1, Dirtygewer cord.
1. Cleanthe bewer cord.
2. Cordjammed.
2. Pull outcordandrewind.
Cleaner leavesmarks on carpel
1. Wrongvacuuming geite_n.
1. Se_ VACUUMINGTIPS, (page9).
19
Publicidad
