Publicidad
Idiomas disponibles
Idiomas disponibles
TRANSIT Quick Installation Guide AMERICAS
Wiring
Power supply wiring
Fuente de Poder: 24 VDC +/- 10%, *500mA.
Especificaciones del Cabo: 2 x 1.5mm (2 x 15 AWG)
Longitud Maxima: 45 metros (140 ft.). de acuerdo con regulaciones en USA y Canada.
Wiegand Wiring
En la figura abajo el wiring de el wiegand protocolo es mostrado.
Longitud Maxima: 45 metros (140 ft.) de acuerdo con regulaciones en USA y Canada
Led Indicaciones
Un numero de LED's es usado para indicar el estado actual. La tabla de abajo describe la function de cada LED.
LED
Description
Status
.
LED
Blinking slow:
STS
Blinking fast:
Blinking twice:
Off:
Identification
ID
This green
LED
The
stays off when no (valid) transponder is identified.
LED
Unlock
.
LED
The unlock
UL
turned off when no transponder is identified anymore and the relay-hold-time has elapsed. This
can be connected to a Reflex or DC130 antenna.
LED
There is also a relay contact present which has the same function.
Lock
.
LED
NA
Red
indicating system standby. This
LED
goes on. This
INP /
Input status
DOOR
This red
LED
+5 VDC
Power LEDs
-15 VDC
Led active indicates voltage is present
+15 VDC
Locked
PLL Locked Led active indicates PLL is Locked
RX Level Led Bar indicating the received tag signal strength. This LED Bar may also indicate the
RX
presence of radio interference.
Page 2 of 4
System's heartbeat (0.8 sec on / 0.8 sec off). Indicates that the power is on
and the processor is running.
Bootloader say's hello. Only indicated for a short period directly after a reset.
Configuration menu active.
Abnormal situation. Should never be off for longer than 1 second.
.
LED
starts to blink fast when a valid transponder is identified.
is normally off and goes on when a valid transponder is identified. The
LED
can be connected to a Reflex of DC130 antenna.
LED
LED
is on when the input contact is closed. The input is used as general-purpose input.
is normally on and goes off when the unlock
LED
is
LED
LED
Page 2 of 4
Publicidad
