Step 14. Check And Correct Door; Alignment - Monogram ZKBSN720NSS Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
STEP 13 ADJUST DOOR SWING
NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to a
90° opening. A 130° door swing option is available
for standard installation only. Skip this step if door
opening is satisfactory for your installation
situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
Remove grille screws
• Use pliers to unscrew door stop and reinstall into the
90° or 130° (standard only) position.
• Reinstall the wire cover trim.
Pin Location
For 90°
Door Swing
WARNING
Door Trim Pinch Point Hazard:
d
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly, and
door stop angle.
STEP 13 ADJUST DOOR SWING
AVERTISSEMENT
doigts : Une installation incorrecte peut poser un risque de
coincement de doigts entre la garniture de porte latérale
et les armoires en actionnant la porte, en particulier pour
les enfants. Pour réduire ce risque, vous devez suivre les
instructions d'installation relatives aux dimensions d'armoire,
au montage des garnitures et à l'angle de l'arrêt de porte.
ADVERTENCIA
con el Marco de la Puerta : Una instalación inadecuada
podrá conducir a riesgos de pellizcos de dedos entre el
marco lateral de la puerta y los gabinetes al utilizar la puerta,
especialmente con los niños. A fin de minimizar este riesgo,
usted deberá seguir las instrucciones de instalación para
dimensiones de gabinetes, ensambles de marcos y ángulos
de detención de puertas.
STEP 14 CHECK AND CORRECT
• Close the grille panel and both doors.
• Check that the freezer drawers and bottom of doors
are horizontal and even at the lower inside corners.
• Carefully measure the inside corners to determine
if an adjustment is needed. A difference of 1/32" is
acceptable and does not reqire adjustment.
SKIP THIS STEP IF DOORS ARE LEVEL.
IMPORTANT: If the doors are not evenly aligned,
they must be removed and spacers must be installed
to raise or lower both doors.
Pin Location
as Shipped
For 115°
Door Swing
Spacer
Location
16
(Cont.)
Risque de pincement de
d
Riesgo de Lastimadura
d
DOOR ALIGNMENT
Spacer
Location
31-1000414 Rev. 1