DOREL Living DL1008BB-1 Manual De Instrucciones página 13

TWIN BUNK BED
DL1008BB-1 / DL1008BB-2
K
T
I
L
4
STEP 6
Insert two slats (T) into the center slots of the bottom side rails (I & K) on the lower bunk as
shown.
NOTE: Once inserted, there should be three empty spaces left on each side.
Insert slats (L) into the remaining holes on the bottom side rails (I & K) on the lower bunk.
Secure slats (L) to the bottom side rails (I & K) with flat head screws (4) using a Phillips
screwdriver (not included).
Repeat this process for the upper bunk.
NOTE: Slats (T & L) will be placed between two wooden blocks.
NOTE: If you notice that any slats (L) are not perfectly flat, be sure to assemble them so
that slats (L) curves up in the middle and down on the ends.