RHINO COFFEE GEAR RCGPORT2KG Manual De Usario página 2

1. Turn on the scale as described above.
2. Place the "tare item" on the platform. Press the "TARE" key and wait until the
LCD displays zero.
3. Your scale can now be used for weighing. Add the "net-weight-item".
Hold Function
Press "HOLD" key to hold the current weight on the display. Press again to
return to normal weighing.
Calibration
1. On the bottom of your scale, slide the switch from your auto-off selection to
'Calibration.' Now the scale is in calibration mode.
2. When the scale is turned off, press ON/OFF key to turn on the scale. Wait
until zero is displayed.
3. Press and hold the "MODE" key until the display shows "CAL", then release
the button. Press the "MODE" key again. The required weight flashes on the
display. Place the required weight onto the center of the platform.
4. The LCD display reads "PASS" and comes back to the normal weighing
mode.
5. Turn the scale over and return the switch from 'Calibration' to your desired
auto off selection.
Selectable Auto Off
This scale comes with Auto-Off enabled. After 30 seconds of inactivity the
backlight will turn off. After 180 seconds of inactivity the scale will turn off.
You have the ability to disable the auto-off by sliding the switch on the bottom
from 'Auto-Off Enabled' to the 'Auto-Off Disabled' position. To keep a longer
battery life, please turn the scale off by pressing the "ON/OFF" key after each
use.
Warning
1. "LO": Low voltage. Please replace the batteries.
2. "EEE": Overload. Please remove item quickly to protect the scale.