Tools And Accessories - Hoover DUAL POWER MAX PET Manual Del Usuario

Tools and Accessories

CAUTION
Always turn off this product before connecting or disconnecting hose.
HOW TO ATTACH HOSE & TOOLS
1
Be sure handle is in upright
position. This will shut off
the power brushes.
2
Open Hose Connection Port.
Insert hose end by inserting
FIRMLY into hose connection
port.
3
Connect tool to hose by
sliding it onto the connector
until it securely locks into
place.
*Tools and Accessories
vary per model.
14
Use extra care when cleaning on stairs. To avoid personal injury or damage, and to prevent the cleaner from falling, always place
cleaner at the bottom of stairs or on floor. Do not place cleaner on stairs or furniture, as it may result in injury or damage.
CLEANING CARPETED STAIRS AND UPHOLSTERY
1
Fill Clean Water Tank
2
according to instructions.
2
Pre-spray the area by
holding the tool about
one inch above the carpet
and push it forward while
pressing the trigger.
3
Press the tool into cleaning
area. Scrub area back and
forth as needed. Press the 3
trigger and pull the tool
slowly over the carpet.
Release trigger at end of
stroke.
4
Position tool nozzle against
wet area. Pull tool slowly
over wet area without
pressing trigger to suction
Read "Before You Begin Cleaning" instruc-
dirty water.
tions page 7. Be sure to check HOOVER®
5
Overlap strokes by ½ inch to
Cleaning Solutions Guide and the cleaning
help prevent streaking. It is
code on your upholstery. Use your cleaner
best to alternate wet and dry
only on upholstery marked "W" or "W/S".
strokes as described in steps.
CAUTION
Tips
To avoid saturating carpet, do not
use more than 4 wet strokes over
any one area. Always end with
dry strokes.
If additional cleaning is
necessary, wait until the carpet is
completely dry before using the
tool again.
Empty Dirty Water Tank when the
motor sound beccomes higher
pitched and there is a loss of
suction. You will also see the
float rise and shut off suction at
the same time.
When finished cleaning, follow
"How to Remove Hose & Tools"
instructions.