Basic Cleaning; Cleaning The Sprayhead Tube - Bunn-O-Matic BT Manual De Instrucciones

BASIC CLEANING

Wash Brew Funnel and carafe after each use.
Wipe the outside of the brewer occasionally, including the
area above the Brew Funnel.
If you're a neat freak, do it more than occasionally.
Important: Do not use an abrasive cleaning device
to clean the carafe, because it will scratch the
stainless steel. Occasionally, remove the brew
through valve on the Thermal Carafe Lid and
clean with mild, non abrasive detergent. To
remove valve, lift at edge and pull up. Be sure
to clean the passage where the valve is located.
To remove coffee stains from inside the Thermal Carafe, place
a paper filter in the Brew Funnel and pour 2 teaspoons of
powder dishwasher detergent into Brew Funnel. Pour one
carafe of water into brewer. Position carafe on Base and close
Lid. When brewing cycle stops, remove Brew Funnel and
discard the filter. Rinse Funnel. Allow Carafe to sit for about
15 minutes. Use a soft bristled brush to clean the inside and
outer rim of carafe. Scrub the Carafe pour lip and Lid with a
soft cloth, warm water and mild detergent. When finished,
pour out the solution in Carafe. Rinse Carafe and Lid.
18

CLEANING THE SPRAYHEAD TUBE

Cleaning the Sprayhead Tube removes deposits due to
natural mineral content in your water. The more mineral
content in your water, the more frequently you should clean.
A good rule of thumb is to do it every 3 months,
Brew Through
Valve
unless you have very hard water then twice a month may be
necessary.
You'll need: metal Deliming Tool provided with your machine,
toothpick, dish soap, soft cloth.
Flip the Tank Switch to the OFF position, unplug brewer and
allow to cool for at least 2 hours.
Remove Brew Funnel and unscrew Sprayhead.
Insert all but 2 inches of the Deliming Tool into
Sprayhead Tube.
Slide Deliming Tool in and out of Sprayhead Tube 5-6 times
to loosen any deposits.