Power Supply - ESA AUTOMATION XS7 Serie Instrucciones Para Instalación

Inserting the PCI or PCIe board
XS has a compartment for a PCI board
(5V, 32bit) or PCIe x1.
Maximum size:
XS712 – 168mm
XS7H2 – 168mm
XS715 – 240mm
XS717 – 230mm
XS719 – 260mm
a. Switch off XS.
b. Optional Dvd-Rom - Remove back
cover.
XS712 – Fig. 18
XS7H2 – Fig. 18
c. Optional Dvd-Rom - Do not remove the
DVD-ROM from XS cover and unplug
the connector. Be careful to not
damage it.
XS712 – Fig. 19
XS7H2 – Fig. 19
d. Remove XS back cover.
XS712 – Fig. 20
XS7H2 – Fig. 20
XS715 – Fig. 33
XS717 – Fig. 45
XS719 – Fig. 57
e. Remove the locking brackets.
XS712 – Fig. 21
XS7H2 – Fig. 21
XS715 – Fig. 34
XS717 – Fig. 46
XS719 – Fig. 58
f. When inserting the PCI board make
sure it makes perfect contact with the
connector (For clarity pictures show
only the PCI board).
XS712 – Fig. 22
XS7H2 – Fig. 22
XS715 – Fig. 35
XS717 – Fig. 47
XS719 – Fig. 59
g. Before completely inserting the board
into the connector check that the
bracket fits into its slot.
XS712 – Fig. 23
XS7H2 – Fig. 23
XS715 – Fig. 36
XS717 – Fig. 48
XS719 – Fig. 60
h. Once the board has been completely
inserted screw to fix it in place.
XS712 – Fig. 24
XS7H2 – Fig. 24
XS715 – Fig. 37
XS717 – Fig. 49
XS719 – Fig. 61
i. Replace XS back cover.
XS712 – Fig. 25
XS7H2 – Fig. 25
XS715 – Fig. 38
XS717 – Fig. 50
XS719 – Fig. 62
j. Optional Dvd-Rom – Plug the connector
and mount the cover.
XS712 – Fig. 26
XS7H2 – Fig. 26
For wiring to the board's connectors
consult maker's guide
Substituting the battery
a. Switch off XS.
b. Remove back cover.
c. Replace the battery on the motherboard
(see motherboard manual).
ATTENTION: Insert the new battery
checking that the polarities are correct.
Discarded batteries should be placed in
appropriate containers.
d. Replace back cover.

Power supply

Fig. 63 - Power connector pin-out.
Fig. 64 - Recommended
connection.
Fig. 65 - Warning:
configuration will seriously damage
components
IMPORTANT:
devices connected to the serial
and/or parallel communication ports
MUST have the same potential as the
0V supply of the XS. The circulation
of current between the 0V supply
and the earth of the communication
ports could cause damage to certain
components of the XS or of the
devices connected to it.
power
These
The earth of
two
the