LiftMaster 371LM Manual Del Usuario

Single Button Remote Control
Model 371LM
For use with garage door openers, gate operators or other products that are 315 MHz Security+
Compatible with garage door openers that have a purple learn button. The code between the remote
control and the receiver changes with each use, randomly accessing over a billion new codes. Refer
to your product manual for the location of the learn button.
NOTE: Your product may look different than the products illustrated in this manual.
WARNING: This product can expose you to chemicals including lead, which are known to the State
of California to cause cancer or birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
PROGRAMMING THE REMOTE CONTROL
1
TO CONTROL THE GARAGE DOOR OPENER LIGHTS
This feature is only available on garage door openers equipped with a multi-function door control and a remote control with more than one button. Not available with universal receiver.
®
With Security+ remote controls, a remote control button can be programmed to operate the garage door opener lights without opening the door.
1
With the door closed,
press and hold
the remote
control button
that you want to
control the light.
TO ERASE ALL CODES FROM MEMORY
When deactivating any unwanted remote control code, all previous codes will be erased.
1
3-Button Remote Control
Model 373LM
®
2
Locate the
Smart/Learn
button.
2
Press and
hold the
+
light button
on the
door control.
Test by pressing the remote control button. The garage door opener lights should turn on or off but the door should not move.
.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate,
or play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are
no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to
cross path of moving gate or door.
3
Press and hold the button
on the remote control
that you wish to use.
Press and
immediately release
the learn button.
The learn LED will glow
steadily for 30 seconds.
Within 30 seconds...
3
Press and
hold the
+
lock button
on the
door control.
Press and hold the learn button
on garage door opener or other
product until the learn LED goes
out (approximately 6 seconds).
All previous codes are now erased.
Reprogram each remote control
you wish to use.
®
SECURITY+ REMOTE CONTROLS
MODELS 371LM AND 373LM
Release the button
when the garage
door opener lights
blink or two clicks
are heard.
If programming to
other products,
press the button a
second time to
activate the product.
After the garage
door opener
lights flash,
release all
buttons.