Wall Mounting The Enclosure; Mounting The Cs16Ac And Cs32Ac; Enclosure Configuration; Door Locks - Tripp-Lite CS16AC Manual Del Propietário

5. Wall Mounting the Enclosure

5.1 Mounting the CS16AC and CS32AC

Warning: Do not attempt to mount the
charging station to the wall with any
personal electronic devices inside.
There are 16 keyhole cutouts on the back door
of the CS16AC and CS32AC enclosures. Each
keyhole can accommodate an M10 or 3/8" bolt
(for the CS16AC model) or an M5 or 3/16"
bolt (for the CS32AC model). Each of the four
keyhole sets are centered 16" apart horizontally
and are spaced in 2.25" increments toward the
outer edges (see corresponding model diagrams
for exact keyhole measurements).
Using a level, measure to position your
mounting areas precisely. Use appropriate
fasteners (not included) to secure the enclosure
to the wall. Once the enclosure is safely
hanging on the fasteners and secured to the
wall, open the unit from the rear door and
tighten all mounting hardware.
Note: The charging station enclosure must be installed by a qualified technician. Before mounting, use a level and tape measure to position your mounting area precisely.
Use appropriate fasteners (not included) to secure the charging station to the wall. Use suitable mounting means when installing to cinder block, concrete, drywall or wood
studs. Warning: The supporting surface must be able to safely support the combined load of the equipment and all attached hardware and
components. Go to the Specifications section for more information on your model's weight and dimensions.

6. Enclosure Configuration

6.1 Door Locks

The front and back doors have locks that are accessible with the included keys.
Each side panel locks using an L-shaped lever on the inside of the enclosure.
1 To unlock and remove the side panels, lift the shorter leg of the "L" up and pull it away from the
side panel. Pull the tab on the side panel and remove it from the enclosure.
To re-lock the side panels, secure it in the proper position, lift the shorter leg of the "L" up and
2
push it toward the side panel, back into the hole that it was in initially. Once it is in place, push
the shorter leg of the "L" down to lock it.
Note: To lock and unlock the side panels, you will need to have access to the interior of the enclosure.
19.375"
17.125"
14.875"
12.625"
16"
16"
17.858"
16"
16"
CS16AC
5
16"
16"
CS32AC
CS16AC
1
2
28.4"
28.4"