Antenna Setup; Antenna Set Up - Diseqc 1.2; East West Limit; Reset Diseqc Limit - InVento IDL-2000S Manual Del Usuario

4. Antenna Setup

4.1 Antenna Set up – DiSEqC 1.2
1. Antenna : You can select a maximum of 16 antennas
with the combination switches.
2. Type: Select your antenna type to DiSEqC1.2
3. Satellite : Select the desired satellite
4. LNB Type : Select your LNB type. If you have universal
LNB, select Univ.
5. LNB Freq. : Enter the proper LNB frequency of your LNB
using the numeric keys on the RCU or use the KEY PAD
displayed by pressing the OK key.
If you have a dual LNB, enter the proper value in the
value box.
6. Switches (22KHz Tone, DiSEqC) : You can select the
switches with which you want to configure the antenna.
7. C/Ku band control : You can select C/Ku band control
by selectiing the switch type.

4.1.1 East West Limit

Selecting Limit Setup button, the Limit Setup menu will pop
up. Press the E key on the RCU continuously to set the
coordinates eastern. Press the OK key.
The message "Would you like to set East limit of DiSEqC
motor?" will be displayed for your confirmation.
Place the OK key to confirm the East limit.
To set West limit, follow the same steps as East limit.

4.1.2 Reset DiSEqC limit

Place the cursor on Reset DiSEqC Limit button and press the OK key. The message "Would you like to
reset limit for DiSEqC positional?" will be displayed for your confirmation.
Press the OK key to confirm.
Select EXIT to finish antenna setup. The message "Are you sure to change the configuration of Antenna
setup?" will be displayed. Press OK wait for the data to be saved.
4.2 Antenna Set up – Fixed
1. Antenna : You can select a maximum of 16 antennas
with the combination switches.
2. Type : Select your antenna type to be fixed
3. Satellite : Select satellite.
4. LNB Type : Select your LNB type. If you have universal
LNB, select Univ.
5. LNB Freq. : Enter the proper LNB frequency of to your
LNB using numeric key on the RCU.
If you have a dual LNB, enter the proper value in the
value box.
6. Switches (22KHz Tone, DiSEqC) : You can select the
switches with which you want to configure the antenna.
7. C/Ku band control : You can select C/Ku band control by selecting the switch type. Select EXIT to finish
antenna setup. The message "Are you sure to change the configuration of Antenna setup?" will be
displayed. Select the OK button on the screen and then wait for the data to be saved.
11