Operating Instructions; Battery Installation; Battery Compartment; Checking For Leaks - Allen + Roth F170185-A1 Manual Del Usuario

OPERATING INSTRUCTIONS

BATTERY INSTALLATION

Make sure the control knob is in the "OFF" position. Unscrew the push button cap on the ignitor
module located on the control panel to access the battery compartment. The ignitor module requires
one AAA size battery (See Figure 7), BATTERY IS NOT INCLUDED.
WARNING:
1. Please observe proper polarity and use the correct battery type when placing or replacing the
battery. Improper installation could result in ignition failure.
2. Please remove the battery if consumed or if product is to be left unused for a long period of
time.

CHECKING FOR LEAKS

To prevent fire or explosion hazard when testing for a leak:
1.Always perform the leak test as described below before lighting this appliance or each time
the cylinder is connected for use.
2.Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3.Conduct the leak test outdoors in a well-ventilated area.
4.Do not use matches, lighters or a flame to check for leaks.
5.Do not use this appliance until any and all leaks are corrected. If you are unable to stop a
leak, disconnect the propane supply. Call a gas appliance service shop or your local
propane gas supplier.
cylinder-regulator connection (Figure 8)
LIGHTING INSTRUCTIONS
1. Push in gas control knob slightly and
turn to "OFF".
2. Turn gas control knob to "ON/MIN".
3. Push in gas control knob all the way
and hold. Continue to press the
ignition button for 15 seconds.
4. If the burner does not light in 15
seconds, release the knob and it will
ON/MIN
pop back out. Wait 5 minutes before attempting
(ENC./MÍN.)
to light the burner again, repeat step 1 to 3.
TO TURN OFF GAS
1. Push in gas control knob slightly and turn to "OFF".
INSTRUCCIONES DE ENCENDIDO
1. Presione ligeramente la perilla de control del gas y gírela a la
posición "APG" (apagado).
2. Gire la perilla de control del gas a "ENC/MÍN" (encendido/mínimo).
3. Presione la perilla de control del gas hasta el fondo y mantenga presionada.
Siga presionando el botón de encendido durante 15 segundos.
4. Si el quemador no se enciende en 15 segundos, suelte la perilla y esta
volverá a su posición hacia afuera. Espere 5 minutos antes de intentar
encender el quemador nuevamente, repita los pasos 1 al 3.
PARA CERRAR EL GAS
1. Presione ligeramente la perilla de control del gas y gírela a la
posición "APG" (apagado)
Figure 7
7
OFF ( A P G . )
M A X
( M Á X . )
1 AAA
IGNITOR
1.5V
( Encendedor )
gas valve-bellows connection (Figure 9)

Battery compartment