Model And Serial Number Location; Check Operation - Electrolux 30 Instrucciones De Instalación

GAS COOKTOP INSTALLATION INSTRUCTIONS
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Preferred Method
Grounding type
wall receptacle
Figure 9

Model and Serial Number Location

The serial plate is located on the underside of the
cooktop (see Figure 10).
When ordering parts for or making inquires about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
of your cooktop.
Your serial plate also tells you the rating of the burners,
the type of fuel and the pressure the cooktop was
adjusted for when it left the factory.
Serial plate is
located under
the burner box.
Figure 10

Check Operation

Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may be hot enough to
cause burns.
1. Install Burner Caps
This cooktop is equipped with sealed burners. All pieces
are at their place. Take note where they are. Remove
all packaging material. Make sure the burner caps are
properly aligned and leveled. The burner cap lip (See Fig.
11) should fit snug into the center of burner head and
(For 30" & 36" Models)
Do not, under any
circumstances, cut,
remove, or bypass
the grounding
prong.
Power supply cord with
3-prong grounding plug.
rest level. Refer to Figs. 12 & 13 for correct and incorrect
burner cap placement. Once in place, you may check the
fit by gently sliding the burner cap from side to side (Fig.
14) to be sure it is centered and firmly seated. When the
burner cap lip makes contact inside the center of the
burner head you will be able to feel it. Please note that
the burner cap should NOT move off the center of the
burner head when sliding from side to side. NOTE: There
are no burner adjustments necessary on this cooktop.
Burner Cap
Burner Head
Correct Burner Cap
Placement - Fig. 12
Fig. 14
2. Place the Grates on the cooktop
Be sure they are correctly located inside the stainless steel
surface.
ATTENTION: Do not slide the grates on the cooktop, doing
so can damage the surface.
36" Cooktop ONLY: Be sure the grates are correctly placed on
the cooktop as shown below. Heat shields must be beside the
knobs.
8
Burner
Cap Lip
Fig. 11
Incorrect Burner Cap
Placement - Fig. 13
Heat shields
Fig. 15