Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
1.
Identify the correct mounting shaft size needed for you application.
Note: If your hitch did not come with a sleeve skip this step.
(2" Receiver) Make sure large sleeve is installed on mounting shaft.
(1 ¼" Receiver) Remove large sleeve from mounting shaft.
2.
Install the anti-rattle hitch stabilizer.
Note: If your hitch did not come with a stabilizer skip this step.
A.
Insert the hitch step and place your hitch pin in position. Push the anti-
rattle hitch stabilizer into the hitch receiver tightly to fill up the gap on
the top of the bar. Mark the exact position.
B.
Remove the hitch step from your receiver. Remove the tape backing on
the anti-rattle hitch stabilizer and reposition the stabilizer 1/16" in front of
your marked position. Press down on the shim firmly to ensure a
secure mount.
2
3. Identify and align the correct mounting hole on hitch step with the factory hitch,
Apply the appropriate size hitch pin (not supplied).
Note: It is recommended that a locking hitch pin be used to prevent theft.
4. For wiring installation, find your vehicle's 4-way flat connector
Note: Some vehicles may require an adaptor or extension cable.
5.
Once installation is complete, make sure lighting functions are
working properly.
Note: Some vehicles may require a load resistor to get the lighting function to
work properly.
ENGLISH
3
Publicidad
