Connect The Garden Hose - Westinghouse WPX2700 Manual Del Usario

ASSEMBLY
FILLING THE FUEL TANK
1. Turn the pressure washer OFF and allow to cool for a
minimum of two minutes before fueling.
2. Place the pressure washer on level ground in a well
ventilated area.
3. Clean area around fuel cap and remove the cap slowly.
Only fill the tank from an approved gasoline container.
Make sure the gasoline container is internally clean and
in good condition to prevent fuel system contamination.
4. Slowly add the recommended fuel. Do not overfill. Fill
only to the top of the fuel screen filter visible in the filler
neck.
Fuel Cap
Screen
Filter
5. Install the fuel cap and tighten until a click is heard.
Fuel can damage paint and plastic. Use caution when
filling the fuel tank. Damage caused by spilled fuel is not
covered under warranty.
Clean the fuel screen filter of debris before and after
each fueling. Remove the fuel screen filter by slightly
compressing it while removing it from the fuel tank.
NOTICE
Maximum
Fuel Level
NOTICE
NOTICE

CONNECT THE GARDEN HOSE

Never connect your pressure washer to a hot water
supply. Connecting your pressure washer to a hot water
source will significantly reduce the life of the pump and
will void the warranty.
The water supply must come from a pressurized water
spicket. NEVER use hot water or water from pools, lakes,
etc. Before connecting the garden hose to the pressure
washer:
1. Run water through the hose for 30 seconds to clean any
debris from the hose.
2. Inspect the screen and gasket in the pump water inlet.
If the screen or gasket is damaged, do not use the
pressure washer until replaced.
3. If the screen is dirty, clean it before connecting the
garden hose to the pump.
4. Completely uncoil the garden hose or remove completely
from reel to prevent kinks.
There must be a minimum of 10 ft. (3 m) of unrestricted
hose between the pressure washer intake and the hose
faucet or shut off valve (such as a "Y" shut off connector).
5. With the hose faucet turned completely off, attach the
end of the garden hose to the pump water inlet. Tighten
by hand.
Do not run the pressure washer without the water supply
connected and turned on, as this may damage the high
pressure seals and decrease pump life. Completely
unwind the hose from its reel or coil and make sure the
hose is not being restricted by tires, rocks, or any other
objects that may lessen or prevent water flow to the
pressure washer
Westinghouse Outdoor Power Equipment, LLC | 11
NOTICE
NOTICE
NOTICE