Meaco DDL8-Z2 Manual De Instrucciones página 11

8. TROUBLESHOOTING AND FAULT CODES
Problem
The unit does not work. The power is not connected.
The water container is full.
The water container has not been replaced correctly.
The air filter is clogged.
The device does not
The temperature in the room where the dehumidifier is
dehumidify.
operating is too low.
The relative humidity in the room where the dehumidifier is
operating is too low.
The house is too large. This dehumidifier can dry up to
about a small five bedroom house.
There are too many sources of moisture. Bathing, washing,
The dehumidifier works,
drying clothes and cooking all puts moisture into the air.
but reduces the relative
Portable gas heating can add too much moisture into the air
humidity insufficiently /
for a dehumidifier.
there is little water in the
water tank.
There is too much ventilation.
The air filter is blocked and the reduce air flow is effecting
performance.
The windows were clear
The outside air temperature has dropped and the windows
and now condensation
are colder.
has returned.
The surface temperature of the windows is too low for a
I cannot remove the
dehumidifier to prevent condensation. Common with single
condensation from my
glazed windows and when the outside air temperature
windows.
drops below freezing.
Dehumidifier is blowing The dried air is passed over a heating element before it is
out warm air. blown into the room as part of the dehumidification process.
Alarm light on Reduced air flow into the dehumidifier.
Smell coming from the
Desiccant wheel has absorbed VOCs from the air.
dehumidifier
Cannot change fan
speed, unit all works in Laundry Mode is selected.
high fan speed
Water not draining down Hose is fitted for continuous drainage but the water still
the hose goes into the tank.
Usually means that the dehumidifier is not on a level
Dehumidifier leaks water
surface or that the filter has not been cleaned often enough
onto the floor
and dirt has fallen into the dehumidifier.
Machine not switching off
Temperature and relative humidity sensor that reads the
and on in the usual 30
room reading is unable to read the correct readings.
minute pattern
9. STORAGE
If the machine will not be used for a long period of time, take the following steps:
1. Remove the plug from the socket and empty the container. Allow the container and the dehumidifier to dry
completely.
2. Clean the air filter and drain plug as per section six.
3. Store the device in a dust-free location away from direct sunlight, preferably covered with a sheet of plastic.
Cause Solution
Insert the plug into the wall outlet.
Remove the water from the container.
Place the water container in the correct position.
Clean the air filter.
The machine does not dehumidify below 1°C, it is highly
unlikely at that temperature that there is any moisture to
remove anyway.
The dehumidifier dries down to the target relative humidity
set and then waits until the relative humidity goes above
the set point again.
We recommend using a dehumidifier with a greater
capacity.
We recommend using a dehumidifier with a greater
capacity. Consider using a different heat source to a
portable gas heater.
Reduce ventilation (e.g. close windows and shut doors.)
Clean the air filter.
Use the dehumidifier on a lower relative humidity target
and run it 24 hours a day.
Keep running the dehumidifier on a lower relative humidity
setting 24 hours a day and when the air temperature
outside increases the windows should clear of
condensation.
This is normal, a dehumidifier is not an air cooler.
Make sure that the filter is clean and the dehumidifier is at
least 50cm from furniture and walls. Reset the error by
leaving the unit unplugged for 15 minutes.
Run the dehumidifier in a separate space free of the VOCs
to clean the wheel.
Turn Laundry mode off.
Negative air pressure in the room is pulling the water back
into the dehumidifier overflow. Insert a 4mm hole into the
top of the tube 30mm down from the spout. This will
introduce air into the tube and balance out the air pressure.
You can also check that the water bucket is not cracked by
filling it with water and placing it on kitchen paper on the
kitchen side.
Clean the filter and blow the air sensor with a hair dryer on
fast setting to clear the sensor of dirt. Unplug the
dehumidifier for 10 minutes to reset its circuits and then
turn back on.
11 [EN]