Important Assembling Advice - ESS Aqua Jewels Linea Consejo Para La Instalación

Important assembling advice: Aqua Jewels
Suitable for renovation work and new construction
Aqua Jewel should only be installed by specialist companies in compliance with the building regulations. To achieve
the best possible result, please carefully read the installation guide. If you have any questions, please consult your
supplier.
▪
Please check the content of the package for completeness and
integrity before proceeding with the assembly. Do not install
the drain if any deviations are noted. Should this be the case,
please consult your supplier.
▪ Prior to the assembly, the assembling advice and its special
characteristics should be discussed with the tiler. After
the assembly, please provide the tiler with the complete
assembling advice.
▪
If the drain is used for several showers, please check to make
sure that the drainage capacity is suf cient. If you are unsure,
please consult the supplier for advice.
▪ If you are not using the second drainage level (secondary
water drainage), the joint between the shower drain and the
tile frame should be sealed with a permanent sealer. See
drawing on page 7 [A].
▪
We recommend taping or closing the drain opening of the
shower drain with a cement cap prior to the assembly to
prevent construction debris from getting into the drainage
pipe. To prevent damage to the tile frame, it should be kept in
the package until the nal installation by the tiler.
▪ Make sure the drain is level all around.
▪
Install the sewage system in compliance with the standards.
Note: ensure that the sewage system is well ventilated and
that the gradient is suf cient.
▪ Check the drainage system and the sewer system connection
for tightness.
▪
In order to prevent hollow spaces, the drain must be fully
lined and sealed with oor pavement to the upper edge of
the ange.
▪ The seal is applied in compliance with the "generally
accepted engineering standards" according to the ZDB
(Central Association of the German Construction Industry)
code of practice 1/2010 "sealing compounds". If alternative
seals are used, please read the manufacturer's product
information.
▪
When tiles are being tted, the gradient of the tiles (min. 2%
per linear metre) in the shower must always be towards the
drain. The tiles should be laid level or 1 mm higher than the
top edge of the tile frame to ensure good drainage toward the
shower drain. Note: the requirements with regard to the oor
gradient may be different for walk-in showers with glass walls.
Please consult your supplier in this respect.
Typing and printing errors reserved. Easy Sanitary Solutions BV excludes all liability for any damages whatsoever associated with the use and/or the installation
10 Linea
of the drain. Easy Sanitary Solutions BV a priori excludes any liability whatsoever.
UK
®
▪
Once the tiles have been tted, the joint between the tiled
oor and the drain should be permanently sealed with an
elastic sealant (maintenance joint). The adhesion surfaces
should be free of mortar, adhesive and other adhesion-
reducing materials. See drawing on page 7 [A & B].
▪
The drain is only intended for use with waste water common
in households. Do not use other uids as well as cleaning
agents with the potential to damage sanitary equipment,
drainage equipment and raw materials.
▪
If the drain is used for other purposes (e.g. swimming pools),
where it may come in contact with aggressive cleaning agents
or corrosive substances such as salt or chlorine, please consult
your supplier.
▪
Compliance with this installation advice is required for any
warranty claims based on our sale and delivery terms.
Caution !
▪ Tile cleaning products often contain aggressive chemicals that
are abrasive in nature and may damage the drain. Please
ensure that the drain is thoroughly ushed after using any tile
and grout cleaning products.