Black+Decker BXVC15PE Manual De Instrucciones página 10

ENGLISH
3.1.12 W
. NEVER use the appliance outdoors in the rain.
arning
3.1.13 W
. DO NOT touch the plug and/or socket with wet hands.
arning
3.1.14 W
. NEVER use the appliance if the power cable is damaged. If the power cable is damaged,
arning
it must be replaced by the manufacturer, one of its authorised Service Centres or similarly qualified
persons in order to avoid a safety hazard.
3.1.15 W
. Check that the appliance is fitted with its data plate; contact your dealer if it is missing.
arning
Appliances without data plate must NOT be used, since they cannot be identified and are potentially
hazardous.
3.1.16 W . NEVER move the appliance by pulling on the POWER CABLE.
arning
3.1.17 W
. The use of non-original accessories and any other accessories not specifically intended
arning
for the model in question is prohibited. All modifications to the appliance are prohibited. Any
modifications made to the appliance shall render the Declaration of Conformity null and void and
relieve the manufacturer of all liability under civil and criminal law.
3.2 SAFETY "MUSTS"
3.2.1 W
. All electrical conductors MUST BE PROTECTED jets or splashes of water.
arning
3.2.2 W
.The electric supply connection must be made by a qualified electrician and comply with IEC
arning
60364-1.Either a residual current device that will cut off the power supply if the leakage current to
earth exceeds 30 mA for 30 ms or a ground fault interrupt device must be installed.
3.2.3 W . DURING start-up, the appliance may generate interference on the electrical system.
arning
3.2.4 W
. Use of a residual current breaker (RCB) will provide additional protection for the operator
arning
(30 mA).
3.2.5 W . Use only approved electrical extension leads with suitable conductor cross-section.
arning
3.2.6 W
. Always turn off the switch when leaving the appliance unattended.
arning
3.2.7 Warning. The air flow may cause parts to rebound: wear all the protective clothing and equipment
(PPE) needed to ensure the operator's safety.
3.2.8 W
. Before carrying out any work on the appliance, REMOVE the plug.
arning
3.2.9 W . Maintenance and/or repair of electrical components MUST be carried out by qualified staff.
arning
3.2.10 W
. Before each use, and periodically, CHECK that screws are tight and all appliance
arning
components are in good condition; inspect for broken or worn parts.
10
(Original instructions)