Step 6: Grease And Attach Mix Tip; Step 7: Apply Adhesive To Surface; Step 8: Shut-Down Procedures; Approved Substrates - OMG PaceCart 2 Manual Del Usuario

Part 2, indicating that both sides are
flowing. Make sure the two sides are
running evenly. Shut valves.
STEP 6: GREASE AND
ATTACH MIX TIP
Grease threads thoroughly before
attaching tip.
Grease threads on mix tip. Attach mix
tip onto the gun. Immediately proceed
to step 7.
STEP 7: APPLY
ADHESIVE TO SURFACE
Dispense material at increments as
specified by the manufacturer.
Open both valves completely and dis-
pense material in a serpentine pattern.
When dispensed with a 1:1 ratio, a
chemical reaction occurs on the sub-
strate, and the material begins to foam.
OlyBond500 is formulated to give the
roofer sufficient time (3–4 minutes) to
place the insulation boards onto the
wet adhesive before it reaches its
tack-free state.
CAUTION
REPLACE THE MIX TIP EVERY
TIME YOU STOP. FAILURE TO DO
SO MAY RESULT IN CLOGGED
GUN AND HOSES.
STEP 8: SHUT-DOWN
PROCEDURES
Always store the PaceCart 2 with
the boxes in place and the gun
greased and pointing downward to
avoid clogging.
Close valves and remove mix tip.
Shut off power switch.
Open valves to drain pressure in
hoses, then shut valves.
Inject grease into gun until it comes
out nozzle tip.
Leave boxes attached while in
storage.
Keep gun pointing downward.
After long-term storage, call OMG for
service at 800 . 633 . 3800.
O M G R O O F I N G P R O D U C T S
8 0 0 . 6 3 3 . 3 8 0 0
W W W . O L Y F A S T . C O M
5
MATERIAL SPEC
OlyBond500 adheres virtually all
common types of insulation to a
wide variety of substrates and is
compatible with and approved by a
majority of roof system manufacturers.

Approved substrates

Approved insulation
®
250
®
FA
™
To determine compatibility with
substrates or insulation not
listed, call 800 . 633 . 3800.
FOR ASSISTANCE
In addition to supplying a broad
array of fasteners and accessories,
OMG Roofing Products has a nation-
wide team of field representatives
that offer services to contractors,
building owners, architects and
roof consultants, including:
assistance and training
For consultation or on-site assistance,
contact OMG at 800 . 633 . 3800.