Care And Storage - Beurer MG 315 Manual De Instrucciones

You can specify the settings as follows:
1. Automatic massage programs
Press the relax, refresh or therapy button.
relax program:
A combination of swing and rolling massage massages your back and neck area.
refresh program:
A combination of Shiatsu and rolling massage massages your back and neck area.
therapy program:
A combination of Shiatsu, rolling and swing massage massages your back and neck area.
2. Shiatsu back and neck massage
Press the shiatsu button. Then use the full, back or neck button to select the desired massage area.
3. Swing back and neck massage
Press the swing button. Then use the full, back or neck button to select the desired massage area.
You can use the spot button to select a spot massage, i.e. Shiatsu and swing massage without vertical
movement. You can change the position of the spot massage by holding down one of the arrows next to
the spot button until the desired position is reached.
4. Rolling massage
Press the rolling button. Then use the full, back or neck button to select the desired massage area.
During the rolling massage you can use the width button to select the distance between the massage
rollers.
If you change the massage type (Shiatsu, swing or rolling massage) the area that was previously selected
is retained. Please note that when you change from spot Shiatsu or swing massage to rolling massage,
you have to select the massage area again.
Note
• Rolling massage and spot massage cannot be selected at the same time.
5. Heating function
Press the heat [15] button to switch on the heating function of the massage heads. The massage heads
light up red at this time.
• Do not use the massage device for longer than 15 minutes and then allow it to cool. Using the device
for longer can over-stimulate the muscles and cause tension instead of relaxation. The massage can be
finished at any time by pressing the
return to the starting position at the lumbar region. This is indicated by the LED flashing. Once this position
is reached, the device switches off.
• If the device is stopped be pressing a massage area button twice, it also returns to the starting position
after 15 minutes and then switches off.
• Do not disconnect the device from the mains supply during operation. Always switch it off first and wait
until it has returned to the initial position.
Note
• The device has an automatic shut-off mechanism set to a maximum operating period of 15 minutes.

8. Care and storage

Cleaning
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
button. Please note that on switching off, the massage heads first
16