AQUARMONY
USER MANUAL
5) IN ST A L L AT IO N
5.1 In wall installation
About its installation, it is very simple to install Aquarmony as it is available in two versions: for the
swimming pools that are already operating and for the swimming pools under construction.
About the first version, it does not require any intervention as the underwater speaker is plunged into
water by a cable and connected to the amplifier system. It is pulled out of the water after its utilization.
Concerning the fixed installation for the swimming pools under construction, Aquarmony is set in the
lamp niches. The loudspeaker can be supplied with the assembling kit in order to make its installation
very easy. Moreover, Aquarmony is provided with the plastic rings to be set better into the niche.
Aquarmony speaker works at best if the middle of the
niche is at 40 cm from the water surface.
In any case, it's advisable not to install the loudspeaker at
more than 60 cm under the water level.
Aquarmony must be completely plunged into water; It
doesn't spread music outside water.
To spread music outside water it's necessary to install
loudspeakers appropriate to the environment and to the
specific requirements.
Put on the neoprene cable in the flexible pipe up to reach the junction box, giving attention that the
cable gland and the gasket are well embedded.
Be sure to have at least 1 m cable length wrapped in the niche in order to be able to carry the
loudspeaker on the edge of the pool.
Screw the cable gland inside the niche by using the provided gasket; screw the cable gland of the
junction box too.
Insert Aquarmony in the niche and be sure that the plastic ring is perfectly adhered to the wall.
Finally, screw tighter the plastic ring to the wall so that the loudspeaker is perfectly fixed in the niche.
2
The electric wire joining the junction box to the amplifier system must not be smaller than mm
2 x 2,5
size.
5
ROKEPO sr
Via Irma Bandiera 6/B
40050 Monte San Pietro
Bologna (Italy)
Tel (+39) 051 616.7254
Fax (+39) 051 616.7255
www.rokepo.it