Accessories; Guide Bar And Saw Chain Combinations; Filing Equipment And Filing Angles - Husqvarna 340i Manual Del Usuario

Recommended cutting equipment for
USA
Following is a list of recommended cutting equipment for
Husqvarna 340i and . This model equipped with either of
the listed guide bar and saw chain combination(s), fulfills
the requirements according to UL 60745-1 and UL
60745-2-13.
Chainsaw models Husqvarna 340i and met the kickback
performance requirements of UL 60745-2-13 when
tested with the combinations of bars and saw chains
listed below. The saw chain Husqvarna H38 is also
classified as a low kickback saw chain since is met the
requirements for low kickback saw chain outlined in UL
60745-2-13. We recommend to use only the listed
combinations of bars and saw chains for chainsaw
models Husqvarna 340i and . Other chainsaw models
may not meet the kickback requirements when equipped
with the listed bar and saw chain combinations.

Guide bar and saw chain combinations

Following is a list of recommended cutting equipment for
Husqvarna 340i and . The listed combination(s) of
Guide bar
Length, in Chain pitch, in
12 mini 3/8
14
16

Filing equipment and filing angles

Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
Husqvarna file gauge to restore the sharpness of the
5/32 in/4.0
93
mm
1155 - 002 - 13.05.2020

Accessories

Gauge, in
0.050
60° 30°
powerhead, guide bar and saw chain meet all
requirements outlined in Canadian Standards
Association Z62.1-11 (Chain saws) and Z62.3-11 (Chain
Saw Kickback).
Furthermore the saw chain Husqvarna H38 is evaluated
and listed as a Type C Low Kickback Saw chain
according to the provisions in Z62.3-11.
Kickback information
The guide bar nose radius is determined by either the
maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius,
you may use a guide bar with smaller nose radius than
in our list. For guide bars of the same length, all
sprocket-nose guide bars of the same pitch and having
the same number of sprocket teeth may be considered
to have equivalent kickback energy.
The following cutting equipment is approved for the
models Husqvarna 340i and .
Saw chain
Max. nose radius Type
7T Husqvarna S93G 45
saw chain. The part numbers are given in the table
below.
If you do not know which saw chain you have on your
product, turn to your servicing dealer.
0.025 in/
0°
0.65 mm
Length, drive
links (no.)
52
56
587 80 587 80
67-01 90-01
35