Kenmore 580.72124 Manual Del Propietário página 7

Ir_ Select the position that wirl place the sill supports
near the outermost point on sill (FIG. 10). Attach the
sill supports to the cabinet track hole closest to the
selected position using screw (ITEM E).
I_ Place the sill supports with the cabinet on the
window sirl's selected position (FIG. 10).
IIEM E
L°wer g ude s. " '_
FIG. 10
_Pi] The cabinet should be installed with a very slight
tilt (about 1/4") downward to the outside (FIG. 11 ).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
ITEM B FIG. 11
_] Attach the cabinet to the inner sill by driving the
screws (ITEM F) through the front lower guide into
the window inner sill. (FIG. 12)
Track
ITEM B
Lower Guide
ITEM F
FIG. 12
_1 Pull each side curtain fully to each side of
window opening. Attach each side curtain to the
window sash using screws (ITEM G). (FIG. 13)
_] Attach the L bracket (ITEM J) with screw
(ITEM G) (FIG. 14).
iTEM G
ITEM J
FIG. 14
IL_JDRAINAGE
Be sure to insert the drain pipe into base pan before
installation. The air conditioner must be installed
with a slight tilt downward to the outside for proper
water drainage (FIG. 15).
_----BASE PAN REAR
DRAIN_
BASE PANBOTFOM
FIG. 15
_J Slide the air conditioner into the cabinet. (FIG. 16)
CAUTION: For secudty purposes, reinstall side screws
'ou removed in step 1.
Power
Cord
Screw
_Jcut the foam seal (ITEM H) to the proper
length and insert between the upper window sash
and the lower window sash. (FIG. 17)
FIG, 17
l/ JigI The II I vent contro, hand,e must be sfra,ghtenedF +8
before the decorative front is attached.
_'_1 __ Pull down part _)to align with part _).Part _)
._i- FIG. 13
_ \"J_22 IlL
-7-