Maintenance & Care; After Cleaning; Machine Storage; Thermal Protector - Bissell SpotClean 5207 Serie Manual Del Usuario

Maintenance & Care

After cleaning

1. Unplug power cord from outlet.
2. Empty and rinse the dirty water tank after
each use, OR when dirty water reaches the
indicated maximum fill line.
a. To remove the dirty water collection tank,
simply lift up on the tank from the base of
the machine.
b. Pull tab to remove plug from tank
c. Rinse out dirty tank with clean water
after emptying.
d. Disconnect the cleaning tool from the
hose grip by pushing down on button lock
and pulling straight off. (Do NOT twist tool
to remove it).
e. The front of the Tough Stain Tool, Deep
Stain Tool & 3-N-1 Stair Tool can be removed
for easy cleaning. Push the button at the
top of the tool and slide the front of the tool
off the base. Rinse both under water and
replace the front of the tool.
f. Check spray nozzle for accumulated dirt or
debris. If necessary, clean with soft bristle brush.
g. The float stack can be removed from the
dirty tank for cleaning. Turn it counter-clock-
wise to remove it. Rinse with water until all
debris is removed. Replace the float stack in
the dirty tank and turn clockwise to lock.

Machine storage

1. Wipe all surfaces with a soft cloth.
2. Wrap power cord around the cord wrap on
the back of the machine.
3. Wrap flex hose around the base of the unit
and secure the spray trigger.
4. Store unit in protected, dry area, at room
temperature (40° to 110°F).

Thermal protector

An internal thermal protector has been designed
into your cleaner to protect it from overheating.
When the thermal protector activates, the suc-
tion motor will stop operating. If this happens,
proceed as follows:
1. Turn the cleaner OFF (O) and unplug from
electrical outlet.
2. Check the end of the hose and tool for
blockages and remove if necessary.
3. Check the float stack for clogs. Refer to
cleaning instructions above.
4. When the motor cools for approximately 30
minutes, the thermal protector automatically
resets and cleaning may continue. If the thermal
protector continues to activate after following the
above steps, your cleaner may need servicing.
Call BISSELL Consumer Care or visit the website.
www.BISSELL.com
8
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
2g.