Mx Onda LEV7200 Manual De Instrucciones página 12

Luz de emergencia para vehículos v-16
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
In the event of a breakdown, abnormality, the plug, the cable or
other parts are damaged, switch off the appliance and do not try to
repair it yourself. Contact the nearest MX ONDA Official Technical
Service.
BATTERY (charge and recommendations for use)
The emergency light battery comes from the factory with a partial
charge and before using it or storing it in the vehicle, you must
charge the battery as follows:
Battery charge
5. With the emergency light off, slide off the cover protecting the 5
Micro USB connector for battery charging.
6. Using the included adapter cable (Micro USB - USB), connect the
emergency light to a USB cigarette lighter adapter or use a power
adapter with a USB output with a voltage of 5 V and capable of
supplying 1 A ( in the case of supplying less current, the battery
charge will be slower).
7. During charging the indicator 4 will light up and when you finish
charging the battery this indicator will go out.
8. After charging is complete, remove the Micro USB connector and
close the connector compartment for charging again.
Very important! When should the battery be recharged?
The battery must be recharged after each use. But you must bear in
mind that this product is for signaling emergency situations and the
battery must be fully charged, so we recommend that you charge
the battery once a month even if you do not use the emergency
light.
HOW TO USE
Momentarily press the on / off button 3 and the light will illuminate in
emergency mode 1 (flashing amber light), pressing this button again
will switch to flashlight mode 2 (steady white light) and if you press
this button again the light will will turn off.

Publicidad

Tabla de contenido
loading

Productos relacionados para Mx Onda LEV7200

Tabla de contenido