Installation - Selecta AGIMATIC-S Manual De Instrucciones

INSTRUCTION MANUAL CODE 80002 REV E
J
.P. SELECTA s.a.u.
S model allows digital reading and control of speed.
N model allows setting a heating level as a rate of total heating
power. To regulate the temperature of the stirred liquid in a better
way, use an electronic controller Sensoterm II as an accessory.
E model allows setting the heater plate temperature. Including
1001610 probe as an accessory, it allows controlling liquid
temperature at same same time that it is stirring.
In some application it is important bearing in mind that heater plate
temperature and the liquid one are very different.
POWER
Maximum temperature (N & E models)
Temperatura resolution (E model)
Heating control (N & E models)
External temperature control connection (N & E models)
Speed
Stirring power
Dimensions
Weight (S model)
Weight (N & E models)
Temperatura limiter (N & E models)

INSTALLATION

Place the stirrer on a flat, horizontal, level surface near the mains.
Connect the connection cable at the rear part of the stirrer base
and then plug it into the mains.
Be sure that the voltage supply is the same as the one
indicated on the characteristics plate.
Do not use the equipment if it is not earthed.
If you change the plug, bear in mind the following:
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: www.jpselecta.es
04/2020
AGIMATIC S
AGIMATIC N
AGIMATIC E
Blue cable:
Brown cable:
Yellow/green cable:
Tel 34 93 770 08 77 Fax 34 93 770 23 62
Page: 13
25W
550W
350ºC
± 2ºC
N:0...100%
E:50...350ºC
Yes
60...1600rpm
10.000ml
14,5x19x26cm
3,0Kg
3,2Kg
370...390ºC
Neutral
Phase
Earth