Settings Menu; Device Configuration From The Urmet Callme App; Important - Urmet 1083/58 Manual De Configuración

2. By pressing the "Settings" key you will display the
following page:
Create or Set Account

Settings Menu

The various functions available on the "Settings" page
are described in the following chapters.
3. Press the "Info" button to see the software
version of the App, access the Urmet website, view
the user manual and read the terms of use and the
privacy policy.
http://www.urmet.com
16
Configure device
Configure app
Logout
Exit
V.2.0-3
User manual
Terms of service
Privacy Policy
4. DEVicE coNfigUrATioN
froM THE Urmet callMe APP
To configure your device, firstly create an account (or
log in using an existing account), as explained in the
"crEATE AN AccoUNT or Log iN" section.
WArNiNg: the device, once fully operational, will
forward calls to the owner of the account that is used
in the configuration step. It is therefore necessary to
use the account of the end user during configuration
operations.
From the Home Page, (with the green dot
and chain closed ) select the "Settings" key.
You will display:
Create or Set Account
Configure device
Settings Menu
From here, select "Configure device".
Follow the steps below:
1. Turn on the call sender device.
IMPORTANT: The device is already in configuration
mode the first time it is switched on (it will take about
50 seconds before the red LED starts blinking) go
directly to step 3.
. Hold the button pressed on the call forwarding
device for 2 to 4 seconds to set it in configuration
mode. The yellow LED will light up.
3. Press the 1XXX/58A button to configure the
following call sender devices:
• 1083/58A for Voice systems;
• 1722/58A for systems with kit 17/81, /83, /84,
/85 and /86;
• 1723/58A for systems with kit 173/71, /7.
Press the XXXX/58 button to configure the following
devices:
displayed
Configure app
Logout
Exit
DS1083-106