Troubleshooting; Important - SodaStream KitchenAid KSS1121 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

IMPORTANT: Before you call for service, check the list of problems and solutions below:
1. Spar_kling Bever_age Maker_ does
not wor_k:
• You might be out of CO
CO
Carbonator by exchanging it for a
2
full SodaStream 60L CO
If you have a Mini CO
installed: bring your empty Mini CO
Carbonator to a participating retailer and
swap it for a FULL 60L Carbonator.
• Check that the carbonating bottle has
been filled up with water to the fill line.
• Ensure that the Sparkling Beverage Maker
is always in the upright position.
• CO
Carbonator may be loose. Do
2
not use tools. Detach the bottle, open
the rear cover, and retighten the CO
Carbonator. Apply firm pressure but do
not over tighten. If the CO
is already firmly in place, it may be empty.
Replace with a full 60L SodaStream CO
Carbonator.
WARNING: Use caution when removing
carbonator as it may be very cold.
2. Cannot pull bottle loader_ tab:
• Make sure carbonation lever is in its fully
upward position.
• Pull bottle loader tab firmly towards you.
3. Cannot install the car_bonating bottle:
• Make sure the carbonation lever is in its
fully upward position.
• Pull the bottle loader tab toward you
until it clicks.
• Insert bottle into Snap-Lock
• Push bottle up and back until it locks.
16
; replace your
2
Carbonator.
2
carbonator
2
2
2
Carbonator
2
2
4. You hear_ CO
escaping fr_om
2
the bottle dur_ing car_bonation:
• Bottle may not be properly attached.
Allow the Sparkling Beverage Maker
to finish the carbonation process and
then you can detach the bottle and
reconnect it following the instructions
in the "Making sparkling water" section.
• It is normal to hear a small amount
of CO
discharge at the end of the
2
carbonating process.
5. You want to r_e-car_bonate a dr_ink
that was alr_eady car_bonated:
WARNING: Never carbonate again
after you have added the flavor. You
may recarbonate only unflavored
sparkling water.
6. If your_ Spar_kling Bever_age Maker_
continues to r_elease CO
carbonation is finished:
WARNING: Do not remove the cylinder
or the bottle. Leave the Sparkling Beverage
Maker in an upright position. Do not touch
it until you no longer hear CO
When the Sparkling Beverage Maker is
no longer releasing CO
carbonating bottle, and call for service.
See "Warranty" section for more
information.
after_
2
escaping.
2
, remove the
2

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Kitchenaid 4kss1121Kitchenaid kss3121

Tabla de contenido