To Set The Alarm In Wood, Drywall, Scan Mode - Itm Delmhorst TechCheck PLUS Manual Del Propietário

3. You may begin taking readings by firmly pressing the back of the meter onto the
4. To hold a reading on-screen, press the HOLD (SELECT) KEY. Press the HOLD
NOTE: The SCAN mode will give relative readings only, not %MC. The numbers displayed
TO SET THE ALARM FOR WOOD, DRYWALL, OR SCAN MODE:
1. If you wish to set the alarm, to beep after a pre-selected value is reached for WOOD,
2. The default status of all alarms is "OFF." Press the HOLD (SELECT) key on the
3. After the alarm is turned on, use the
4. After you have selected the alarm value, use the  key to highlight EXIT. Press the
5. The chosen alarm value will be displayed on the WOOD, DRYWALL, or SCAN mode
Note: Default alarm settings are: WOOD - 15% DRYWALL – 1%, SCAN - 300.
1.800.561.8187
material to be tested. This will display a relative reading that ranges between 0 and 300.
(SELECT) KEY again to return to measuring mode.
represent the relative dryness or wetness of the material on a scale of 0 to 300. In
order to accurately interpret your readings, first establish a baseline reading by taking
a reading in an area you know to be unaffected or dry, then take a reading in the
affected or wet area and compare the two readings.
DRYWALL, or SCAN use the
ALARM. Press the SELECT key to enter the alarm sub menu.
desired alarm to turn it on.
decrease alarm value.
center HOLD (SELECT) key to return to MAIN MENU.
screen and an audible alarm will sound if that value is reached.
www.

keys from the MAIN MENU screen to highlight the

key to increase the alarm value, and the  key to
Copyright  2009, Delmhorst Instrument Co.
.com
Page 7 of 35
information@itm.com