Sound Adjustments - Brandt BTD-200BT Manual De Instrucciones

To preset stations
You can save up to 20 FM radio stations to the memory.
1. Tune in to the station to be preset.
2. Press MEM on the remote control.
• A preset number "P01" will be shown on the display.
3. Repeatedly press CH+ / CH- on the remote control to select the preset number where you
want to save the station.
4. Press MEM to store the station into the selected preset number.
5. Repeat the above steps to save all the desired stations.
To listen to a preset station, press CH+ / CH- on the remote control to select the station.
FM and FM stereo reception
When the unit is tuned in to a stereo broadcast with a good signal, "STEREO" will be shown on
the display.
If an FM station is received, but has interference, it is recommended to switch to MONO mode
by pressing MO/ST on the remote control.
CONNECTION
RCA cable
The connection cables are not included.
1. In power on state, press SOURCE until the desired function (AUX or LINE) is selected.
2. Turn your connected equipment on and operate it as usual.
• The sound from the equipment will be heard through the unit.
3. Adjust the volume level to the desired listening level.

SOUND ADJUSTMENTS

Mute
1. Press MUTE on the remote control to turn off the sound.
2. Press MUTE again to restore the sound to the previous level.
• "MUTE" will disappear on the display.
• You can also press VOL+ or VOL- to restore the sound.
Audio cable
EN-6