Operation (continued)
12
Resetting the light fixture to
factory settings
If the password is forgotten, the light fixture may be
reset to the original factory settings.
□
Touch the light icon.
□
Touch "Restore Factory Defaults".
□
Follow the on-screen instructions to restore
all light settings back to the original factory
settings.
Care and Cleaning
□
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray the light fixture with a hose or power washer.
Troubleshooting
Problem
The light will not come on.
The light comes on during
the day.
Possible Cause
□
The light switch is turned off.
□
The fuse is blown or the circuit
breaker is turned off.
□
Daylight turn-off (photocell) is in
effect.
□
The circuit wiring is incorrect (if this
is a new installation).
□
The motion sensor is aimed in the
wrong direction.
□
The outside air temperature is close
to the same as a person's body
heat.
□
The motion sensor may be installed
in a relatively dark location.
11
7:15 AM
68%
Porch
Settings
Rename Light
Restore Factory Defaults
Cancel
Android
Solution
□
Turn the light switch on.
□
Replace the fuse or turn the
circuit breaker on.
□
Recheck after dark.
□
Verify the wiring is correct.
□
Re-aim the motion sensor to
cover the desired area.
□
Increase the "Sensitivity"
setting.
□
The light fixture is operating
normally under these
circumstances.
Please contact 1-866-308-3976 for further assistance.
9:25 PM
100%
ATT
Back
Porch
Settings
Rename Light
Restore Factory Defaults
Cancel
iOS
HOMEDEPOT.COM