Connections - Metra Electronics Axxess MITO-03 Instrucciones De Instalación

From the 16-pin harness to the aftermarket radio:
• Connect the Blue/White wire to the amp turn on wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Tape off and disregard the following (6) wires , they will not be used in this application:
Blue/Pink, Brown, Green/Purple, Light Green, Orange/White, Red
2

CONNECTIONS

From the MITO-03 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Orange wire to the Illumination wire (If applicable).
12-pin pre-wired ASWC-1 harness & 3.5mm jack:
• This harness and 3.5mm jack is to be used along with the optional ASWC-1 (sold separately) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If
it will be used, refer to the vehicle specific ASWC-1 instruction from Axxess Interfaces for radio
connections and programming. Disregard the harness that comes with the ASWC-1.