Troubleshooting - Klarstein 10029263 Manual De Instrucciones

Timer ON:Press „TIMER ON" button that LED will display 1H-8H for option. The fan will stop
working after the time is set.
Timer OFF:Press „TIMER OFF" button that timer function will be cancelled
+ Press "-" button to decrease airflow. There is total five level speed.
Press "+" button to increase airflow. There is total five level speed.
-
Swing: press "SWING" button that LED will display "12" means oscillate in 120°and press again to
display "90" means oscillate in 90°,press third time to display "60" means oscillate in 60°,press
fourth time to display "30" means oscillate in 30°and press fifth time to display "00" to cancel
oscillation
Replace the remote control battery
1. Rotate the battery cap clockwise with the hand or
screwdriver and follow the direction as indicated by
the arrow. Align the arrow in the cap with the square
to remove the battery cap.
2. Install the battery. Fit the cap and rotate the battery
cap anticlockwise to align the arrow in the cap with
the arrow in the body of remote control.
Notice for remote control
• The infrared receiver is located in the bottom of LED display.
• The remote control should be pointed at the LED display when pressing any button on the remote control to get
the best signal transmission.
• Suggest to use remote control between 45°when the fan swing sideway.
• Don't put any obstructions between the receiver and remote control.
Problem Possible Cause
Power indicator light
No power to the fan.
does not turn on.
The voltage is too low.
Airflow is slow.
Air inlet or outlet is blocked.

Troubleshooting

Suggested Solution
Check if outlet is working.
Consult with electrician.
Check the fan if it' s on the level surface.
Check the power switch is on or not.
Don't restart until the voltage is back to nomal.
Clean the air inlet or outlet.
8