Intended Application - SSS Siedle BNG 650-0 Informacion De Producto

English
Application
Bus line rectifier for Siedle In-Home
bus: audio in switch panel housing
for power supply to the bus users.

Intended application

This device may only be installed and
used to supply the Siedle In-Home
bus, as described in this document
and in the system manual. Any other
use is prohibited and not in accord-
ance with the intended use, the
manufacturer accepts no liability for
the consequences of such use.
Electrical voltage
• Mounting, installation and ser-
vicing work on electrical devices may
only be performed by a suitably
qualified electrician.
Failure to observe this regulation
could result in the risk of serious
damage to health or fatal injury due
to electric shocks.
• For surface mounting, ensure that
"protection against direct contact"
with active parts is provided. For
details, consult VDE 0100/DIN 57100
part 410.
• Observe DIN EN 60065! In a
building installation, an all-pole
mains switch with a contact opening
of at least 3 mm must be provided.
The device must not be exposed
to water drops or sprayed water!
Sufficient ventilation must be
ensured. Pay particular attention to
ensure that ventilation slots are not
covered.
• When using stranded cores as
cable material, these must be fitted
with wire end ferrules without fail.
4
USA version
The line rectifier in the 125 V version
may only be operated in a closed
switch cabinet. Covering solely with
the ZAP 9-0 is not sufficient. The
125 V variant may only be used
in conjunction with ITE devices.
(Information Technology Equipment)
Scope of supply
• Line rectifier for top hat rail
mounting
• Siedle In-Home bus system manual
• This product information
Accessories
ZBVG 650-...: Is required in systems
with more than one line or for
programming the in-home bus via
a Windows PC (BPS 650-...) and
PRI 602-... USB. Only one unit
may be installed within the Siedle
In-Home bus.
Mounting in distribution cabinet
1 Clip the bus line rectifier onto the
top hat rail.
Surface mounting
(only 230 V version)
2 Surface mounting only using
accessory ZAP 9-0. Clip the provided
latches onto the back of the line rec-
tifier. Mount the device on the wall.
Installation and commissioning
Installation, commissioning and pro-
gramming are described in the Siedle
In-Home bus system manual.
Terminal assignment
L1, N Power connection
Ta, Tb In-Home bus
(Bus user supply)
Sa, Sb System bus audio (Multiple
line system networking)
c, b Power supply 12 V AC
Tö, Tö Relay contact door release
(Max. 24 V, 2 A)
Li, Li Relay contact light
(Max. 24 V, 2 A)
Specifications: BNG 650-0
Operating voltage: 230 V AC,
+/-10 %, 50/60 Hz
Operating current: 200 mA
Output voltage: 27.5 V DC, 12 V AC
Output current: 0.5 A DC, 1 A AC
Fusing: Primary fuse 1 T 250 mA L,
secondary short circuit proof
Contact type:
2 n.o. contacts 24 V, 2 A
Protection system: IP 30
Ambient temperature:
0 °C to +40 °C
Horizontal pitch (HP): 9
Dimensions (mm) W x H x D:
162 x 89 x 60
Specifications: BNG 650-1
Operating voltage: 125 V AC
+/–10 %, 50/60 Hz
Operating current: 360 mA
Fusing: primary fuse 1 T 500 mA L,
secondary short circuit proof
For further technical specifications
see above