Palram Neo 1350 Manual De Instrucciones página 4

C!II
Door Cover
Attention!
Please read these
instructions carefully before you start to assemble this product.
Please
carry
out the
steps
in
the order set out
in
these instructions.
Keep
these instructions
in
a
safe
place for future reference.
Safety Advice
Sort the parts and check against the content
list.
For safety purposes we
strongly recommend the product
be assembled by
two
people.
We
strongly recommend the
use
of work gloves during assembly.
Do not
attempt
to assemble the Door Cover in
windy or wet conditions.
Always wear shoes and safety goggles.
Dispose
of
all plastic bags safely
-
keep
them out of
reach
of
small
children.
Keep
children away from the assembly
area.
Do
not attempt to assemble the Door Cover if you
are
tired,
have taken drugs,
medication
or alcohol, or if you are prone to dizzy spells.
When using
a
stepladder or power tools, make
sure
that you follow the manufacturers
safety advice.
Be
sure
to check that there
are no
hidden
pipes or cables in
the wall before drilling.
Please
consult your
local
authorities if any permits
are required to install
a
Door Cover.
Before assembly, consider the door's opening (inside or outside).
Please
apply silicone sealant to the
rear edge in
order to prevent water
seepage.
Tighten all screws when completing assembly.
Keep
roof
and
gutter
clear
of
snow,
dirt
& leaves.
Heavy snow load on roof can damage the product making it unsafe to stand below or
nearby.
Cleaning
instructions
Clean
the product once assembly
is
complete.
When your Door Cover needs cleaning,
use
a
mild detergent solution and rinse
with
cold
clean water.
Do
not
use acetone, abrasive cleaners or
other
special
detergent to
clean
the
panel.
Additional information
The wall anchoring kit supplied
with this product
is
suitable only for concrete walls.
Other wall types need
an
accordant wall fixation kit.
Please
apply silicone sealant if needed
You are
solely responsible for
determining whether the handling,
storage, assembly,
installation or
use
of this product
is
safe
and appropriate
in
any location or for any given
application.
Palram
is
not responsible for any damages or injury to
you, any
other
person
or
any
property resulting from the improper handling,
storage,
installation, assembly or
use
of
this product, or the failure to follow
Palram's
written instructions regarding the handling,
storage,
installation, assembly and
use
of this product.
This
product
is
intended for normal
residential use
only. Do not
use
this product for any application that
is
not recommended
in
these
instructions or building
codes
in
effect
in
location where this product will be used.
Always take care and
use
appropriate safety equipment (including
eye
protection) when
assembling or installing this product.
Before Assembly
Please note:
Steps marked
with
dashed
outlines
refer
to
Extensions only.
Please
note the
sizes
needed
in
order to place and connect the brackets to the wall.
Some
of the
steps are
irrelevant for
an
assembly of
a
single canopy.
When assembling
a
single or an
extended canopy, some parts may
be surplus.
During Assembly
When
encountering the information
icon, please refer to the relevant
assembly step for additional comments and
assistance.
Step 1: Plan
the assembly according to the number of canopies purchased.
Step 2:
Sizes in
accordance with Step
1.