Installing The Axgm-04; Initializing The Axgm-04; Adjusting The Axgm-04 - Axxess AXGM-04 Manual De Interfaz

Installing the AXGM-04

With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AXGM-04 harness, into
the interface.
• Connect the AXGM-04 harness to the wiring harness in the vehicle.
Note: If using the AXSWC, connect it after you initialize and test the AXGM-04,
with the key in the off position.

Initializing the AXGM-04

Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an AXSWC connect it after you initialize and
test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, pause for a moment, and then to the accessory
position. Test all functions of the installation for proper operation, before
reassembling the dash.
AXGM-04

Adjusting the AXGM-04

Audio level adjustment:
• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the
audio level; counterclockwise to lower the audio level.
• Once at a desired level, audio level adjustment is complete.
Chime level adjustment (for models without a digital amplifier *):
• With the vehicle on, turn it off and leave the keys in ignition. Open the driver's door;
chimes will be heard.
• Wait 10 seconds, and then with a small screwdriver, turn the potentiometer
clockwise to raise the chime level; counterclockwise to lower the chime level.
• When the chime is at a desired level, remove the keys from the ignition. This will
lock the chime volume at its current level.
* Please reference the "Service Parts Identification" sticker located in the glove box
for the RPO code Y91. If Y91 is present, then the vehicle is equipped with a digital
amplifier. Refer to the vehicle owner's manual to adjust the chimes.
OnStar Level Adjustment
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN button on the
steering wheel to raise or lower the OnStar level.
• If the vehicle does not come equipped with steering wheel controls, or they no
longer function, locate the Black/Yellow wire on the AXGM-04 harness.
• While OnStar is speaking, tap the Black/Yellow wire to ground. Once the OnStar level
is set, it will stay at that level until the Black/Yellow wire is tapped to ground again.
5