FIRST USE
When first use, rotate the battery compartment cover counterclockwise to pull off.
Insert 1*AA alkaline battery (not included), ensure the (+) and (-) marks on batteries face
the same marks in the battery compartment. Place cap back on unit using the alignment
marks and rotate clockwise until the cap snaps into place.
USE
Replace the cover, repeating the above procedure in reverse and twist it so that it locks
shut.
Remove the protective head cover before use.
To trim ear hair:
• Turn on the appliance and insert it in the exterior of the ear (Do not insert more
than 0.5 cm).
• Carefully move the trimmer around the area with hair.
To trim nose hair:
• Turn the appliance on and insert it in the nose (Do not insert more than 0.5 cm).
• Remove the nose hair by moving the appliance in small circles.
MAINTENANCE AND CLEANING
• Make sure that the switch is in the OFF position before removing, replacing or
cleaning the blades. Clean the appliance after each use using the cleaning brush
to remove all the hair.
• Clean the appliances with a damp cloth impregnated with a few drops of
detergent and dry it after
• Do not use solvents, or products with an acid or basic pH factor such as bleach,
or abrasive products, for cleaning the appliance.
• When necessary apply lubricating oil to the blades. Finally, replace the protective
cover for correct maintenance.
• For a more thorough clean, remove the cutting head.
• Separate the bottom blade from the outer blade. Use a paper tissue to clean any
hair, dust, etc. off the blades. Next, refit the cutting head, turn it to the right until
mark lines up with.
TECHNICAL PARAMETER
• Model: TH.CP018.
• Battery: 1* AA, 1.5V (not included).
• Voltage: 1.5V.