Programming The Remote Control - Gira 0588 Serie Manual De Instrucciones

Programming the remote control

N.B.: The EIB equipment which the Instabus /
IR converter is intended to control or the EIB
sensors controlling the Instabus / IR conver-
ter must have been programmed into the
device beforehand during commissioning.
If it is desired to control other consumers, the
device must be reprogrammed. For repro-
gramming, the EIB commissioning software
(e.g. ETS3) is needed. In this case, contact
your electrical fitter.
For programming an IR remote control key
into the Instabus / IR converter proceed as
follows:
1. Slide the switch at the bottom of the
device into the 'LEARN' position. The IR
window is now lit up green.
2. Trigger the selected sensor function (e.g.
by depressing an EIB pushbutton briefly
or also for a longer time). The IR window
is now lit up orange.
3. Actuate the key of the remote control to
be programmed briefly two times.
The distance between the remote control
and the Instabus / IR converter should be
approx. 30...40 cm.
The IR window confirms the first key-
press by flashing orange once and the
second key-press by flashing orange
three times. After this cycle the window
shines green again.
4. Continue to program further IR channels
(step 2) or terminate the 'Learn' mode
(slide switch to position 'ON').
12
i
Important
• Make sure during programming of the IR
keys that the keys of the remote control
are pressed as briefly as possible. The IR
command will other-wise be stored re-
peatedly so that there may be malfunc-
tions.
• An IR window flashing three times red
indicates a fault.
The IR window shines green now. Repeat
the procedure with step 2 or abort (slide
switch to position 'ON').
• If the slide switch is in the 'LEARN' posi-
tion, and if no confirmation has been given
within 2 minutes, the Instabus / IR conver-
ter terminates the procedure. The IR
window flashes green (in one-second in-
tervals) and the device has no function.
End the 'Learn' mode (slide switch in pos.
'ON'.
• Note the key assignment of the IR remote
control.
Example
Remote Key
control
TV „darker"
Action
dining room
roof lamp off