Preparing For Use - Oster FPSTHS3610 Manual De Instrucciones

L E A R N I N G Y O U R H A N D / S T A N D M I X E R
You can use the mixer to mix and knead. The mixer can be easily removed from the
stand in a moment and used as a standard hand mixer.

PREPARING FOR USE

Placing and securing the mixer to the stand (figure 2).
Before placing and securing the mixer to the stand, switch unit off "O" and unplug
from the electrical outlet. Press the tilt button and tilt the cradle back. Place the
grooves located in the bottom of the hand mixer (see figure 2) onto the tips of the
holding base of the stand. Then push the back of the hand mixer down until it locks
into place with a click sound. To remove it, push the lower end of the Lock & Release
Latch and lift the hand mixer up then forward.
INSERTING/ EJECTING BEATERS & DOUGH HOOKS
Before releasing the Beaters or Dough Hooks, switch off the mixer and remove
the plug from the electrical outlet. Push the Beaters or Dough Hooks into the slots
located under of the mixer, until they click into place. The two Dough Hooks have
different plug shapes and must be pushed into the correct slots. Inserting the wrong
way would lead the dough to "move" upwards. One of the Dough Hooks has an
additional small ring near the collar on the shaft. This Dough Hook will only fit in the
slot for which it is intended. To remove the accessories, hold firmly with one hand,
while pressing the Beater Ejector Button (figure 3).
Combo_Jetsons FPSTHS3610_FPSTHS3611_FPSTHS3612_20SEM1 (LA).indd 4 Combo_Jetsons FPSTHS3610_FPSTHS3611_FPSTHS3612_20SEM1 (LA).indd 4
(figure 2)
(figure 3)
E n g li sh -4
4/10/20 10:56 4/10/20 10:56