Operation - Thetford SANICON TURBO 700 Manual Del Propietário

Ocultar thumbs Ver también para SANICON TURBO 700:
Tabla de contenido

Publicidad

Overview
Congratulations on your purchase of the SANICON® Turbo
system - the cleanest, most sanitary, and convenient way
to empty your RV holding tank!
Read and understand the warnings listed in this
!
WARNING
ATTENTION
document before you operate or service this sys-
tem. If you do not obey these warnings there is a
risk of property loss, injury, or electrocution. Do not
make any changes to this unit as this could result
in property damage, injury, or electrocution.
Thetford Corporation accepts no responsibility or liability for
damage to equipment, injury, or death that may result from
the system's improper installation, service, or operation.
Thetford Corporation recommends that plumbing and
electrical work be performed by a licensed trades person.
Local permit and code compliance is required.
Cautions and Warnings
Read and understand the warnings and cautions listed in
this document before you operate, or service this unit.
Wear appropriate personal protective equipment
!
WARNING
ATTENTION
when using the SANICON® system.
Do not make any changes to this unit, as this could
AVISO
AVIS
!
NOTICE
CAUTION
result in property damage or injury.
Flush only organic human waste and
toilet tissue. Do not fl ush non-dissolving
articles such as feminine hygiene products, paper
towels, or moist towelettes, as this will damage the
macerator and will void your warranty.
To avoid pump failure, if you are using an acces-
sory garden hose on the end of the nozzle, make
sure that the inner diameter of the hose is .75 in.
(1.9 cm) or greater.
The pump is suitable for indoor and outdoor use.
NOTICE
Thermal Cut-Off Switch
Because SANICON® Turbo pumps are designed for inter-
mittent duty, the pump contains a thermal cut-off switch for
your safety. Typical run time is 15-20 minutes of operation
before the thermal shut-off switch turns the pump off. After
20 minutes, the thermal cut-off switch will reset and allow
the pump to run again.
■ If the pump is run immediately after a thermal reset, it
will run for approximately five - eight minutes.
■ If allowed to cool for several hours it will run the full 20
minutes.
97515 Rev. F (07/03/2019)

Operation

Questions?
If you have any questions or need assistance, please
contact Customer Service at 1-800-543-1219, available
Monday through Friday 8 a.m. to 6 p.m., Eastern Standard
Time.
Pump Performance
Performance varies with hose size and length:
& Length
SANICON
®
hose 1.5 in. x 21 ft.
SANICON
®
hose 1.5 in. x 21 ft.
SANICON
®
hose 1.5 in. x 21 ft.
w/ 100 ft. - .75 in. garden hose
®
SANICON
hose 1.5 in. x 21 ft.
w/ 100 ft. - .75 in. garden hose
SANICON
®
hose 1.5 in. x 21 ft.
w/ 50 ft. - .75 in. garden hose
Thermal cut-off will occur after 20 minutes. Refer to "Thermal
i
Cut-Off Switch" discussion.
Attach To Pump Station
Refer to the Fig. 1.
1. Open hose storage compartment (
(
) and nozzle (
F
coach.
NOTICE
2. Unscrew large nozzle cap (
3. Attach universal nozzle (
Empty Black Water Tank
Refer to the Fig. 1.
1. ENSURE universal nozzle (
dump station! Refer to "Attach to Dump Station" proce-
dure.
NOTICE
2. Open black water tank gate valve (
3. Turn pump on.
4. Do no leave unit unattended.
NOTICE
5. Turn pump off.
6. Close black water tank gate valve (
2
Hose
Height
9 ft.
0
9 ft.
0
0
J
) with caps; do not disconnect from
G
Remove cap (
) for full hose extension.
H
).
H
) to dump station.
G
) is securely attached to
G
TIP For Cleaner Storage: Emptying the black water
tank fi rst, allows gray water to cleanse the system.
M
TIP: The hose expands as fl uid moves to dump
station and contracts when tank is empty.
SANICON
Flow
Minutes to
Rate
Empty 100
(gal/
Gallons
min)
11.1
9
18.7
5
0.7
143
i
3.7
27
i
6.2
16
); pull out hose
).
).
M
®
Turbo - Model 700

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido