Dri-Eaz F245 Manual Del Usuario

HydroSensor I & II Moisture Probes
Phone: 800-932-3030 Fax: 360-757-7950
Conveniently detect moisture in carpets, pads, furniture, walls and other materials.
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
NOTICE: The sensor points of the
HydroSensor probe are extremely sharp. Take care
when collapsing the telescoping tubes to avoid the
points extending by accident. This could cause
injury. Always retract the probe points into the shaft
when not in use.
BEFORE YOU BEGIN
Warranty registration
Visit warranty.LegendBrandsRestoration.com to register your
purchase. Registration allows us to better assist you with us-
ing, maintaining or servicing your equipment and to contact
you in case we have important safety information concerning
your Dri-Eaz product. If you determine service is required,
have your equipment model, serial number and original proof
of purchase available and call your distributor for assistance
with obtaining a return material authorization (RMA).
INTRODUCTION
The HydroSensor Moisture Probes I & II are designed to detect
moisture in carpets, cushion, floors, walls, furniture and other
materials. When the probe tips are pushed into materials to
penetrate the surface, an electric current is sent between the
probes. The amount of moisture present in the material deter-
mines how easily the electrical current passes from one probe
to the other.
When moisture is present in a material, the light on the Hy-
droSensor will flash and the transducer will beep. The faster
the rate of flashing and beeping, the higher the level of mois-
ture.
The 7/8" probe tips are long enough to penetrate shag carpets,
cushion, and flooring materials. With care, the HydroSensor
can also be used to find moisture in furniture, walls, and ceiling
materials.
The HydroSensor will also detect the presence of urine resi-
dues. This is because urine salts attract and hold enough
moisture to be detected. A black-light is recommended to con-
firm that urine is present.
07-00315E F245, F251
Owner's Manual
Models F245, F251
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA 98233
Patents: http://www.LBpatents.com
1
http://LegendBrandsRestoration.com
OPERATION
1. When using the HydroSensor II, first extend the shaft.
Grasp the smaller-diameter tube and slide it out until the
spring button pops into place.
2. Extend the sensor points at the bottom of the probe. Loosen
the black plastic knob. Push it down and around the S-
shaped slot, then tighten the knob to lock in position.
3. Test the unit by placing your fingers across the shaft of the
points. The indicator lamp will light and the unit will beep.
4. Probe the suspected moisture area with the points. Flash-
ing and beeping indicates that carpet and/or pad are wet. A
faster rate of beeping/flashing indicates a higher level of
moisture.
5. Take care not to apply too much force on the probe. Excess
force may damage the tips or telescoping tubes.
6. Always retract the sensor points when not in use.
Dri-Eaz Products, Inc.