Test Rangetop Burners - Forza FRT304GN Manual De Instalación

Test Rangetop Burners

Install any loose components, such as burner caps and grates that may have been removed earlier. Be certain that burner
caps seat properly into the burner bases. Before testing operation of the appliance, verify that the unit and the gas supply
have been carefully checked for leaks and that the unit has been connected to the electrical power supply. Turn the manual
gas shut open position.
Test Burner Ignition
Select a range top burner knob. Push in and turn counterclockwise to HI. The ignitor/spark module will produce a clicking
sound. Once the air has been purged from the supply lines, the burner should light within four (4) seconds.
Test Flame: High Setting
Turn burner on to high. See Figure for appropriate flame characteristics. If any of the rangetop burners continue to burn mostly
or completely yellow, verify that the burner cap is positioned properly on the burner base, then re-test. If flame characteristics do
not improve, call Forza.
Test Flame: Low Setting
Turn burner on to Low. Verify that the flame completely surrounds the burner. There should be a flame at each burner port
and there should be no air gap between the flame and the burner. Fan each of the flames out and allow to reignite to verify
burner reignition. If any burners do not carry over, call Forza.
Repeat the Ignition and Flame Test procedures, described for each range top burner.
If the flame is completely or mostly yellow, verify that the regulator is set for the correct fuel. After adjustment, retest.
Some orange-colored streaking is normal during the initial start-up.
Allow unit to operate 4-5 minutes and re-evaluate before making adjustments.
When Flame is Properly Adjusted: There should be a flame at each burner port. There should be no air gap between the flame
and burner port.
Call Forza if:
1) Any of the burners do not light.
2) Any of the burners continue to burn yellow.
Yellow Flames
Further adjustment is required
Yellow Tips on Outer Cones
Normal for LP Gas
Soft Blue Flames
Normal for Natural Gas
24