Start-Up; Remove The Iso-Strip; Inserting/Changing Batteries - ADE KE 1600 Instrucciones De Operación

Start-up

Remove the iso-strip

The batteries are already inserted on delivery and, for protection against premature
discharge, are provided with an iso-strip. In order to activate the scales, you must
remove the iso-strip. The battery compartment is located on the underside of the
device.
1. Loosen the fastening screw of the battery compartment cover using a fine Phillips
screwdriver.
2. Push the locking tab slightly towards the middle of the scales and remove the
battery compartment cover.
3. Pull the iso-strip out.
4. Put the battery compartment cover back in place and secure it using the fastening
screw.

Inserting/changing batteries

To use the scales, you require 2 batteries of the type CR2032, 3V (included in scope of
delivery). The battery compartment is located on the underside of the device.
1. Loosen the fastening screw of the battery compartment cover using a fine Phillips
screwdriver.
2. Push the locking tab slightly towards the middle of the scales and remove the
battery compartment cover.
3. Push the batteries against the contact springs under the large, angular retaining
tabs. The batteries then snap into the opposite retaining collars, such that the
batteries sit firmly in their retainers.
Pay attention to the correct polarity (+/-). The plus pole (+) for both batteries must
point upwards.
4. Put the battery compartment cover back in place. The locking tab must snap
securely into place.
5. Secure the battery compartment cover using the Phillips screwdriver.
Notes on changing the battery:
‚ A change of batteries becomes necessary when "LO" appears on the
display, or when nothing at all is displayed.
‚ Only use the type of battery that is specified in the "Technical Data".
‚ Always change both batteries at the same time.
‚ Dispose of batteries in an environmentally appropriate way (see
"Disposal")
Kitchen Scales KE 1600
Start-up
17