AirComfort 6104TRB Manual De Instrucciones

D E E P SL E EP TW IN RA IS E D A I R M ATTRE S S
INSTRUCTION MANUAL - MODEL# 6104TRB
Puncture Resistant
Designed with durable laminated
PVC material that's puncture
resistant and air tight.
Convenience
16" height makes getting
into and out of the bed
extremely easy.
DISCLAIMER:
GREAT CARE AND ATTENTION HAS BEEN TAKEN TO ENSURE THE QUALITY OF THIS PRODUCT. WE ARE NOT LIABLE FOR ANY ACTIONS THAT MAY
RESULT IN INJURY, DEATH, DAMAGE TO PROPERTY, OR LOSS OF INCOME.
LIMITED WARRANTY:
THIS AIR BED IS GUARANTEED TO BE FREE FROM DEFECTS IN MATERIALS AND WORKMANSHIP AT THE TIME OF PURCHASE. ANY DAMAGE THAT
OCCURS AFTER PURCHASE AS A RESULT OF NORMAL USE (SCUFFS OR PUNCTURES) IS NOT COVERED BY THIS WARRANTY AND IS THE SOLE
RESPONSIBILITY OF THE CUSTOMER.
INFLATING WITH EMERGENCY FILL VALVE:
IN THE EVENT OF A FAILURE OF THE BUILT-IN PUMP,. THIS BED IS EQUIPPED WITH A SECONDARY INFLATION VALVE. EXTEND SMALL VALVE OUT
FROM SIDE OF BED. OPEN VALVE CAP AND FILL BED WITH EXTERNAL PUMP (NOT INCLUDED). DO NOT USE A HIGH PRESSURE PUMP. A
MANUAL PUMP - SUCH AS A FOOT PUMP OR BIKE PUMP WITH ADAPTER IS RECOMMENDED. CLOSE VALVE CAP AND PUSH VALVE BACK INTO
BED WHEN DONE. DO NOT OVERINFLATE.
Diamond Coil
Ultra soft sueded diamond
coil top for maximum comfort
and air flow.
Twin Sheets
Standard twin sized
sheets fit perfectly on
the air mattress.
CUSTOMER SERVICE: 866-498-5269 / WEB: AIRCOMFORTBEDS.COM / 4009 DISTRIBUTION DR #240, GARLAND, TX 75041
General Care and Maintenance Instructions
Do not let product come in Do not smoke while
contact with tools, pets, or using. Keep away
sharp objects that may from open flames.
puncture material.
Important Safety Information and Warnings:
• Do not over or under inflate
• CAUTION: After inflation, a change to hot weather will
cause air to expand. You must release air to prevent
airbed from deflating due to overpressure. A change
to cold weather will cause air to contract. You may
need to add air to maintain firmness.
• Avoid using in extreme temperatures.
• Keep away from sharp edges, nails, or any sharp or
pointed objects.
• Do not stand, walk, or jump on bed. Do not allow
children to play or jump on bed.
• Keep away from open flame and heaters.
Setting Up / Storing Away
Inflating:
1) Check your sorroundings for any sharp
objects on the ground/floor that may cause
damage to the bed (nails, screws, sharp
rocks, etc.)
2) Unfold the bed and lay it flat on the floor.
3) Ensure the pump is in the "OFF" position.
4) Connect the pump cord to an electrical
outlet as shown above.
5) Make sure the air inlet vents are clear of
any obstructions.
6) Rotate the pump knob clockwise to the
"INFLATE" position as shown.
7) When the air mattress reaches the desired
firmness rotate the pump knob back to the
"OFF" position as shown.
DO NOT OVERINFLATE. INFLATE UNTIL
THE WRINKLES IN PVC ARE ALMOST
GONE, AND THE MATTRESS IS FIRM.
Clean product with mild Never unfold or inflate
soap and water only. the product in cold
temperatures.
• Do not smoke on the bed.
• This is not a life saving device. Do not use as a
flotation or as a water toy.
• Do not let young children sleep on this mattress until
mature enough to sleep in an adult bed. Young
children can suffocate, especially in the case of
unexpected deflation. Never leave a child unattended
or sleep on same mattress as a young child.
• Fill with cold air only. Never use a hair dryer to inflate.
• Maximum Weight: 350 Lbs/ 158 Kgs Total.
Deflating:
1) Connect the pump cord to an electrical
outlet as shown above.
2) Rotate the pump knob counter-clockwise
past the "OFF" setting to "DEFLATE"
3) Allow the bed to fully deflate, and then turn
the knob to the "OFF" position.
4) Disconnect the pump cord from the outlet
and place it into the cord storage pocket.
5) Fold the bed and place into the carry bag
if desired.
OPEN SWITCH