Speaker Connections - SAS BAZOOKA MARDI GRAS Manual De Instalación

Make the speaker connections using speaker wire that is at least 12 gauge or heavier.
As with any audio component, proper phasing of the amplifier and speakers is essential for
strong bass response. When connecting, make sure that positive (+) from the amplifier is
connected to the positive (+) of the speaker, and the same for negative (-).
2 Ohm 2 Ohm
(1 Ohm Minimum) (1 Ohm Minimum)
2 Ohm 2 Ohm
(1 Ohm Minimum) (1 Ohm Minimum)
CAUTION!
The amplifiers must see a 1 Ohm load or higher for the subwoofer(s). Any lower
than the above mentioned impedance will cause the amplifiers to overheat and possibly cause
permanent damage to the amplifiers.
S
PEAKER CONNECTIONS
1
CHIL
MIN
FUSE 30A X 4
- -
+ +
1
CHIL
MIN FUSE 30A X 4
+ + - -
+ + - -
Dual 4 Ohm Woofer Dual 4 Ohm Woofer
*2 Ohm load recommended for best efficiency
and to optimize the power output.
+12V TURN-ON GND
+12V TURN-ON GND
11