Low Battery; Led Indicators - Ncredible PLAY Manual Del Usuario

Low Battery

• You'll hear a voice prompt of "Low battery, please charge"
when the battery level is less than 10%.
Note: iOS users will see the NCredible Play Wireless Earbuds
battery life indicator on your home screen when connected to
your device.

LED Indicators

• When your NCredible Play Wireless Earbuds are charging –
the red LED light is on.
• When your NCredible Play Wireless Earbuds have finished
charging – the red LED light will turn blue.
• When your Bluetooth is being paired – the red LED light and
blue LED light flash quickly.
• When your Bluetooth is disconnected – the red LED light
flashes quickly.
8
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
En
9