BRINKS 7234BZ Instrucciones De Instalación

Congratulations on your purchase of a Brink's Wall Light with Motion Detection. You have purchased a safe, dependable, and easy-to-install security lighting system. You can use this fixture at home
for outdoor lighting applications.
WHAT'S INCLUDED: A - Lantern Base
Connector G - Nut Caps (4) H - Mounting Bracket Screws (2)
IMPORTANT SAFETY INFORMATION
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH ALL APPLICABLE INSTALLATION CODES.
INSTALLATION MEETS LOCAL, STATE, AND NATIONAL CODES.
PRIOR TO INSTALLATION: Carefully read through the entire installation instructions before installing this security light fixture.
WARNING: BE SURE POWER IS OFF AT MAIN POWER PANEL/FUSE BOX BEFORE INSTALLING OR REPLACING FIXTURE. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE
WITH THE APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
INSTALLATION INSTRUCTIONS
2. Insert two (2) Fixture Mounting Screws (D)
3. Attach Swivel Mounting Bracket (C)
a. Connect the Black wire from the EZ-N-Stall
b. Connect the White wire from the EZ-N-Stall
connector (F) to ground screw located on the mounting bar.
d. Plug the EZ-N-Stall Connector (F) into mating connector from fixture as shown in Figure 3.
™
FIGURE 1
then secure using two (2) Nut Caps (G) as in Figure 4. Tighten Nut Caps (G) clockwise.
lens.
9. Attach Lens Housing (E) to Fixture Base (A) with two (2) Cap Nuts (G) as shown in Figure 4.
IMPORTANT: Apply a weatherproof silicone caulk or sealant around the fixture base to reduce chance of water leaking into the fixture body.
.
MOTION SENSOR SETTINGS -
INITIAL SET-UP
sensor can assume normal activity.
RANGE
sensor sensitivity. Counterclockwise will decrease the sensor sensitivity. A lower setting (counterclockwise) would reduce false
triggering by small animals.
TIME (Duration)
minutes.
then will turn OFF per your selected time setting.
TEST
motion sensor to be active during daylight hours.
FOR OPTIMAL OPERATION
TROUBLESHOOTING
Does not function at all
Light cycles ON and OFF
Light is continuously ON
LIMITED LIFETIME WARRANTY
how to have defective product repaired or replaced free of charge. LIMITATIONS - This warranty only covers Brink's assembled lighting products and accessories and is not extended to other
NOT LIABLE FOR INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES
limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. NOT COVERED - Product failure
Hampton Products International Corp.
B - Wire Connector (2) C - Swivel Mounting Bracket w/ ground screw
(C)
™ Connector (F) to the Black wire of the supply circuit using Wire Connectors (B).
Connector (F) to the White wire of the supply circuit using Wire Connectors (B).
™
GROUND SCREW
FIGURE 2
Brink's trademark & copyright work are used with permission.
D - Fixture Mounting Screws (2)
(C).
(B)
(F)
FIGURE 3
(D) - which you installed onto Mounting Bracket (C) earlier,
MODEL NO. 7234BZ
WALL LANTERN with MOTION DETECTION
INSTALLATION INSTRUCTIONS
E - Lens Housing
Tools Required: Phillips Screwdriver, Silicone Sealant or Caulk
(G)
(D)
(C)
(E)
FIGURE 5
RANGE
PHOTOCELL
Made In China
F - EZ-N-Stall™
(A)
(G)
FIGURE 4
8
1 T
TIME