QuickCable RESCUE 4000 Manual De Instrucciones página 3

• Remove the lower back panel. (Refer to Fig. 2)
• Loosen the battery hold-down strap and install the battery. Tighten
the hold-down strap to make sure the battery is secure.
• Connect the positive cable (identified with red heat-shrink near the
connector) to the positive battery terminal.
• Connect the negative cable to the negative battery terminal.
• Reinstall the back panel. (Fig. 2)
3. Rescue 4050 only.
• Connect the supplied air hose to the threaded air outlet on the
back panel. (Fig. 3)
Using your Rescue
Charging the internal battery
• The battery charger power cord is permanently
installed and wrapped around the cleats on the
back of the unit.
• Plug the unit into a 120V AC outlet.
• Set the rocker switch on the front of the unit to
INTERNAL. (Fig. 4)
When the battery is charging, the LED light will be lighted red. When the battery is fully
o
charged the LED will turn green.
The charger will go to float mode when the battery is fully charged (13.6V).
o
Check the charge of the internal battery using the battery test button and voltage gauge
o
on the front of the unit. (Fig. 6)
Charging an external battery
• Be sure the switch on the back of the Rescue 4000/4050 is in the OFF position before
connecting clamps to a battery.
• If the voltage reading is below 5V, OR if there is no reading at all on the volt meter,
DISCONNECT THE BATTERY CABLES. DO NOT ATTEMPT TO CHARGE.
Connect the positive (red) battery clamp to the
o
positive terminal of the battery to be charged.
Connect the negative (black) battery clamp to the
o
negative terminal of the battery to be charged.
The voltmeter on the front of the Rescue
o
4000/4050 will automatically read the voltage of
the external battery.
If the voltage is above 5V, plug the power cord
o
of the Rescue 4000/4050 into a 120V AC outlet
and set the rocker switch on the front of the unit to
EXTERNAL. (Fig. 5)
When the battery is charging, the LED will be
o
lighted red. When the battery is fully charged, the
LED will turn green.
4000/4050
®
WARNING – Risk of explosion or fire
Fig. 4
Fig. 5
Fig. 6
Fig. 3
3